The Neophyte's Custom Liquid Cooling Guide: How To, Why To, What To Expect
- Posted in
- Cases/Cooling/PSUs
- Systems
- G.Skill
- Corsair
- Gigabyte
- Haswell
- Water Cooling
- Plextor
- NVIDIA
- Overclocking
- Swiftech
Thankfully, good practice also happened to be the easiest thing to do. Before powering on the system, you need to fill the pump and reservoir with coolant and get the coolant circulating while checking for leaks. I actually happened to have a separate 4-pin molex power supply handy from a USB hard drive kit, so I was able to power the pump without needing to even touch the AX1200i. You really don't want to run the pump without coolant in it any longer than you have to, but you'll want a decent amount of coolant in the reservoir to start (have a towel handy in case you accidentally overfill like I did) and then slowly add coolant until it's clear you don't need any more. For me, I had a pretty good idea I didn't need any more when the whole thing overflowed again. But at least I didn't have any leaks.
Leave the pump running for a few minutes, and rock the case back and forth to work air bubbles out of the system. Take a flashlight and look at each of your interconnects and make sure none of them are leaking. For the record, I wound up going through about one and two-thirds bottles of the HydrX.

After getting coolant circulating through the system and all of the air out (you'll know the air has been released when the coolant level in the reservoir has a sudden drop and there are no leaks), I went back to threading all of the power cables and very carefully cramming everything into that hopelessly small space.
The last problem I ran into had to do with Swiftech's PWM splitter. While it's supposed to take the PWM signal from the motherboard and split it among all of the fans connected to it, the fans all wound up just running at full speed. It's tough to figure out exactly where the blame lies or if it's just an incompatibility. Honestly, I think a rig like this is pretty much the ideal situation for a Corsair Link kit, where extremely tight and flexible software control of multiple PWM channels is vital. Gigabyte has made a fantastic motherboard here in the G1.Sniper 5, but their fan control is still woefully lackluster.
Apart from my fan control woes, though, I found that I was ready to close the shiny new system up and get to testing.
Originally published at https://www.anandtech.com/show/7363/the-neophytes-custom-liquid-cooling-guide-how-to-why-to-what-to-expect (Wayback Machine).





