Archive 1997–2024

BenQ XL2720T Gaming Monitor Reviewed

Looking at the white uniformity of the BenQ XL2720T, we see a large drop-off in the upper left, and another drop on the right side that isn’t quite as drastic. I like to see everything stay within 5% of the center value ideally, which means 180-220 nits if the center is at 200 nits, but this one measurement drops down to 167 nits and is clearly darker. The right side only drops down to 172 nits, but that is still fairly low. Most of the display stays within that 5% threshold, but on the edges it has an issue.

With the black uniformity, we see some bright corners on the left side, and the surrounding numbers are much lower than they are, and with an all-black screen it is quite easy to tell the difference. The center actually has the highest black level of anywhere other than that one bright corner.

The contrast uniformity on the display varies by a lot. The center comes in at 795:1 (not quite the 820:1 we measured earlier, but the black reading changing by as little as 0.001 nits can influence this highly), but the rest of the monitor swings from as low as 754:1 to as high as 946:1. With contrast ratio higher is going to be better, but looking at the chart really shows that the overall uniformity of the white and black levels on the BenQ isn’t ideal.

The grayscale uniformity shows this as well. The center is still quite good, coming in at a dE2000 of 0.92. The reason for the higher value here than on the calibration page is that uniformity testing uses 0%, 20%, 40%, 60%, 80%, and 100% values, not 0-100% in 5% increments. Since the 0% value is the highest, it has added weight here, but doing uniformity testing with all 21 values would be unreasonably time consuming to do. We see that the dE2000 rises up to 3.46 in that hot-spot on the left side of the screen, and has a few other areas above 2.0 as well. Most of the screen is still good, and as I said these numbers might be lower if I measured 21 points per location, but that’s still a large difference on the display.

With the colorchecker uniformity, we see the same issues, only worse. Since the colorchecker starts with a higher error than the grayscale, we see that many points on the screen have managed to rise above 3.0, which is considered not visible to the human eye when in motion. We also see that corners are measuring really well, while the center of the screen is further off. This is a bit strange, but overall the uniformity isn’t as strong as with other displays.

Originally published at https://www.anandtech.com/show/6963/benq-xl2720t-gaming-monitor-reviewed (Wayback Machine).