Archive 1997–2024

The Enermax Liberty - Getting long in the tooth, but still worth a look

Secondary Side


The PCB that is home to the jacks used for the cable management looks very clean and appears to be of good quality. This is better than some other PSUs where we've seen a huge amount of solder all over the place. The modular cable design also eliminates a lot of clutter from the insides of the PSU, particularly when done in this fashion using a PCB. Even if the resistance were to increase slightly because of the modular cable connections, the improved airflow may help to offset this. Only the 24-pin/ATX-12V connections have wires in the interior of the PSU enclosure.



The secondary side looks good as well. The cables attached to the PCB have small shrinking hoses on the end for protection if they loosen from the board. On the left side we can see a small chip on the PCB that includes the protection features of this power supply. It is a chip called PS223 from the Taiwanese company Silicon Touch Technologies. This kind of chip is used often by Enermax and we have never encountered any problems with its functions as well. It combines support for Over Voltage Protection, Under Voltage Protection, Over Current Protection, and Over Temperature Protection.

The Fan



The Liberty has a large 12cm fan installed that blows air onto the components and heatsinks. It's manufactured by Globefan, another company whose parts are often used in Enermax products. It can run at a nice low speed of under 1000 RPM, but when necessary it can spin at over 2000 RPM.

Originally published at https://www.anandtech.com/show/2289 (Wayback Machine).