915 Motherboard Roundup: Socket 775 for the Rest of Us
- Posted in
- Motherboards
Jetway 915 PDBG: Overclocking and Stress Testing
FSB Overclocking Results
| Front Side Bus Overclocking Testbed | |
| Processor: | Pentium 4 Prescott LGA 775 560 ES (2.8GHz-3.6GHz) |
| CPU Voltage: | 1.425V (1.3875V default) |
| Cooling: | Thermaltake Jungle 502 |
| Power Supply: | OCZ Power Stream 520 |
| Maximum CPU OverClock: | 214x18 (3852MHz) +7% |
| Maximum FSB OC: | 216FSB x 16 (+8%) |
While the Jetway is a decent performer at stock speeds, the overclocking performance is pretty dismal. The options are there for this board to be a good overclocking performer, but it appears that Jetway has done little with the 915 design, since the demand has been so low in the market. We hope that if Jetway decides to bring the 915PDBG to market, they will update the BIOS to improve overclocking performance significantly.
Memory Stress Test Results:
Jetway designed the 915GDBG and 915PDGB to use DDR memory. Memory stress tests therefore measured the ability of the Jetway to operate at its officially supported memory frequency of DDR400, at the best performing memory timings that our standard OCZ PC3200 Platinum Rev. 2 will support. Memory stress testing was conducted by running DDR400 at a stock 1:1 ratio with 2 DIMM slots operating in Dual-Channel mode.| Stable DDR400 Timings - 2 DIMMs (2/4 DIMMs - 1 Dual-Channel Bank) |
|
| Clock Speed: | 200MHz |
| Timing Mode: | 1:1 (200:200 - Default) |
| CAS Latency: | 2.0 |
| Bank Interleave: | Auto |
| RAS to CAS Delay: | 2 |
| RAS Precharge: | 2 |
| Cycle Time (tRAS): | 5 |
The Jetway 915PDBG was completely stable with 2 DIMMs in Dual-Channel at the DDR400 and memory timings of 2-2-2-5 at 2.6V default voltage.
Filling all four available memory slots is more strenuous on the memory subsystem than testing 2 DDR2 modules on a motherboard.
| Stable DDR400 Timings - 4 DIMMs (4/4 DIMMs - 2 Dual-Channel Banks) |
|
| Clock Speed: | 200MHz |
| Timing Mode: | 1:1 (200:200 - Default) |
| CAS Latency: | 2.0 |
| Bank Interleave: | Auto |
| RAS to CAS Delay: | 3 |
| RAS Precharge: | 2 |
| Cycle Time (tRAS): | 5 |
DDR has a long benchmarking history that makes it easier to figure out where to go with memory timings. We found that the RAS-to-CAS delay needed to be increased to a 3 setting for complete stability with 4 DIMMs in the Jetway. 4 DIMMs were completely stable at 2-3-2-5 settings at a default 2.6V memory voltage.
Originally published at https://www.anandtech.com/show/1561 (Wayback Machine).