Archive 1997–2024

Intel's E7205: Granite Bay Hits the Streets

Gigabyte 8INXP: Board Layout

We had some minor complaints about the layout of this board, but not too many overall.

Looking at the positioning of the ATX (20-pin) connector, we see that Gigabyte places it on the right-hand side of the motherboard. This is the best place to position an ATX connector, as the thick wires won't obstruct the installation/uninstallation of the HSF or passive North Bridge heatsink, as well as any other components that you may decide to modify or uninstall. The ATX connector should be located a bit higher, ideally at the very top, right-hand corner of the motherboard.

All three onboard fan headers are placed well. The system and power fan headers are located at the edge of the right-hand portion of the 8INXP. This way, fan wires won't have to travel far to their destination. The third fan header however (the CPU fan header) was placed a bit too close to the CPU clamps and DIMM connectors. This makes it somewhat difficult to sneak your fingers in there to unplug the CPU fan line, but this isn't too much of an issue unless you have large fingers.

As is now common with almost all P4 motherboards, the ATX12V connector is located on the left-hand side of the motherboard. This isn't the best location for the ATX12V connector though (especially since it's located towards the midsection of the motherboard), as this connector ends up in your path of uninstalling the HSF. The ATX12V connector should be placed at the very top of the motherboard, somewhere on the right-hand portion of the board preferably.

We're glad that Gigabyte places the Primary/Secondary IDE connectors to the right of the DIMM slots and just above the midsection of the motherboard. We've experienced what a hassle it can be to have the Primary/Secondary IDE connectors placed on the lower portion of the motherboard. It makes it more difficult for the IDE cables to reach to the uppermost bays of a large-sized ATX case, and might have even got tangled up with our video card.

There are a lot of motherboard makers that place their DIMM connectors too close to where the video card is installed. However, Gigabyte is good enough not to make the same annoying mistake, and places their DIMM connectors far enough away from our GeForce4 Ti4600. We always like it when mainboard manufacturers do this because we're not forced to uninstall the video card if we want to uninstall memory.

There are two, well-positioned USB headers on this motherboard, located at the bottom of the board below the two green IDE RAID connectors. This is the best place to position the USB headers, as it has little chance of getting tangled up with any other wires or hardware components.

Originally published at https://www.anandtech.com/show/1033 (Wayback Machine).