Archive 1997–2024

Silverstone Raven: A New Concept in Case Cooling

Inside

The case design concept is indeed very different, and even if the cooling isn't any better there are almost certainly people that would still approve of this case design. However, we think that the cooling design is effective, since heat should exhaust easier through the top of the chassis. You can also get fresh air for some important components without having to draw air through the entire chassis; for example, a power supply with a 120mm fan on the bottom gets direct access to fresh air. Higher end GPUs should also get access to a lot of fresh air from the side panel vents. A 120mm fan serves as the primary exhaust at the top of the case, and Silverstone again uses positive air pressure with more intake fans than exhaust fans in order to optimize cooling.


Towards the front of the case are six hard drive cages that can be removed by opening the appropriate lever and sliding them out. This allows you to easily install hard drives, and small rubber grommets isolate the hard drives and keep them from touching the rest of the chassis. This should reduce vibrations and thus decrease noise levels. The drive bay on the left includes a back plate that enables hot swapping of that hard drive. Optical drives use the same mounting system Silverstone has used in other cases.

One of the interesting benefits of the case design is that you shouldn't have to worry as much about graphics cards causing flex on your motherboard. They can now hang from the top of the case and shouldn't sag. In addition, you can use a support bar that reaches across the motherboard to help secure the graphics cards. The bottom of the case has a ton of space, so you can easily install even the longest of power supplies. The air filters at the bottom are easily removed for cleaning, although you will need to remove the side panel for some of the filters. Finally, there's a bit of extra room behind the motherboard where you can route some smaller cables if you desire, but it's not a particularly large area so you won't be able to route all of the cable harnesses that way.

Originally published at https://www.anandtech.com/show/2720 (Wayback Machine).