Archive 1997–2024

Antec Fusion HTPC Shootout

Antec Fusion Remote Max Performance

Once again, we attached temperature diodes to the CPU cooler (as close as we could get to the area where it makes contact with the CPU), the chipset heatsink (IGP graphics), on top of the hard drive, and hanging in the middle of the chassis between the front and CPU cooler for the ambient readings.


When we compare the readings from the CPU cooler to the two readings from the two previous cases, we already see a temperature increase of 5°C in idle conditions. This is caused by the different alignment of the fans, and it indicates two 120mm fans beside each other work better than the constellation we see with the Fusion Remote Max. It could also mean that this constellation does not work that well with the Zalman cooler we selected; perhaps something like a tower cooler would be a better in this case. The other three readings are similar to the previous results and don't show much of a difference between the different fan speeds.


The difference between idle and load is quite small with the Fusion Remote Max. In general, we didn't see much of a difference between the different fan speeds on any of these cases. At most, selecting the highest fan speed only reduced temperatures by a few degrees. Since these are all HTPC designs, users are far more likely to want to set the fans to minimum speed in order to keep noise levels down. Thankfully, these cases should work just fine that way.

Originally published at https://www.anandtech.com/show/2637 (Wayback Machine).