Archive 1997–2024

Antec Fusion HTPC Shootout

Installing the Components

Since the Fusion Micro is so small, installing the components is a bit tricky. We removed the power supply not because there was no space but because it was hooked up to our Chroma ATE. It's a good idea to install the motherboard before anything else, since otherwise some of the other components can get in the way. The Zalman cooler we selected fits nicely under the top cover with a centimeter or two spacing. Installing the hard drive requires you to remove the hard drive cage, which necessitates the removal of the VFD first. You can then slightly cage back into place, and the cage rests on rubber feet to dampen noise. Similarly, installing optical drive requires you to first remove the drive cage and install the CD/DVD/BRD. You will want to test the positioning of the drive and make sure the button matches up with the front before fully tightening the screws. Even with the limited space, we didn't have any problems fitting all of the components inside. Just make sure you select the right components up front; otherwise you will need to dismantle much of the case in order to swap components. During operation, we couldn't hear any noise from the power supply, and the result was a very quiet system overall.

Due to its height, it is a little easier to install the components in the Fusion Remote Black. The motherboard is still a tight fit without much room on the sides, but with a bit of patience you shouldn't have any difficulties installing it. Be sure you don't have any cables going through the opening at this stage, since the motherboard will not be able to pass. Installing the hard drives is simple, and you can secure them with the special rubber noise dampening screws that come with the chassis. There is some extra space above the power supply that you can use to store cables if you don't have a modular PSU.

Installing the Micro ATX motherboard into the largest of the three cases is easy as you would expect. Even if you are installing a normal ATX motherboard there is sufficient space to get it into place. The hard drives have the same mounting frame that we find in the Fusion Remote Black. Be careful with the front mounted hard drives, though, since the space is very limited and the separation wall can bend/break the connectors. It would be useful to have angled SATA connectors here so that they won't press up against the casing. If you are installing a long power supply like the Antec Signature series, be sure you pass all of the necessary cables through the little opening in advance since after you install the power supply you might not have enough room to feed additional cables through. For example, we had to remove the PSU before we could pass the 24-pin ATX cable through the opening.

Originally published at https://www.anandtech.com/show/2637 (Wayback Machine).