Archive 1997–2024

Corsair DDR3-2133 - How high and fast will it go?

First Results



First up are the maximum stable FSB shots. These come in at 2V on the memory and around 1.67 VMCH. That's probably too high for the conservative overclockers among us, not to mention these settings favor a water-cooled Northbridge. In testing, 555FSB is absolutely stable, performance is okay, but we had to set "Enhanced Data Transmitting" to disabled in the DFI BIOS.

Read bandwidth in our Everest test is just over 11K here as is write speed. Copy bandwidth suffers because of the disabled performance registers, posting a mere 9K or so. The numbers are respectable enough, and the DFI board can certainly run two 3870s in CrossFire mode at a somewhat high FSB speed. Let's push for a better performance ratio.



We usually prefer running our PCs where they perform best, and typically for the X48 chipset this performance zone falls at a tRD of 6 with the FSB speed at around 460-470. Although, the downside of running a lower FSB does manifest itself with lower overall copy and write speeds, so we sometimes settle for a tRD of 7 at 500FSB. In this instance, the stock specification of these modules demands 533FSB and that means a looser tRD of 8 on all X48 boards.

Now comes the reason behind the perceived synergy of the parts we are using together. Usually, running the 2:1 memory divider on the X48 chipset over 510FSB requires a lot of the chipset performance registers to be set low. The DFI board has a bit of an advantage here over other boards; it can run and hold these performance enhancements steady at 533 FSB. The result is spectacular bandwidth right across the spectrum, while access latency is also no slouch.

Voltage-wise, the MCH demands between 1.6V and 1.65V to remain stable with these loads. Again we find ourselves using fans that provide a copious amount of noisy airflow or a decent water loop to keep the Northbridge cool for a 24/7 system running these speeds (and even with such cooling, we're far more inclined to drop the speeds a bit). Of course, it's possible to loosen tRD to bring the VMCH down, but the logic in doing so does not sit well with the decision to purchase a CAS 9 2133MHz memory kit.



Yes, our settings are fully stable, but the motherboard still exhibits a tendency to sit staring back at us with a code 88 displayed in the POST code display when we cold boot the system. Simply reloading the BIOS gets around it, so it's just a matter of tidying up the BIOS by DFI to rectify our problem. A complete BIOS guide will follow shortly as part of the full board/memory review. The story for now is that yes, DDR3-2133 speeds or higher can be done for a 24/7 system, but be prepared for a few days of tuning and hair pulling. It's just not that easy yet.

Originally published at https://www.anandtech.com/show/2605 (Wayback Machine).