The Gigabyte GA-X48T-DQ6 - Redefining the High End?
- Posted in
- Motherboards
450FSB BIOS Settings
These settings should prove useful for Q6600/QX6800/QX9650 CPUs, with the Q6600 currently being the most popular (and affordable). If a non boot is experienced when applying these BIOS profiles after a cleared CMOS or BIOS reset - increase tRD shown in the profiles by +1. A looser tRD will help the board complete the initial boot cycle. Re-enter BIOS,move the tRD back down by -1. Remember not to change memory divider/ CAS or Northbridge strap during the same reboot as tightening tRD.
| Gigabyte GA-X48T-DQ6 Bios Settings @ 450FSB | |
| Robust Graphics Booster | Turbo |
| CPU Clock Ratio | 8x (Q6600/QX6800) 9x (QX9650) |
| CPU Frequency | 450FSB |
| CPU Host Clock Control | Enabled |
| CPU Host Frequency (MHz) | 450 |
| PCI Express Frequency (MHz) | 100 |
| C.I.A.2 | Disabled |
| Performance Enhanced With | Extreme |
| System Memory Multiplier | 4.00B |
| DRAM Timing Selectable | Manual |
| CAS Latency Time | 8 |
| DRAM RAS# to CAS# Delay | 8 |
| DRAM RAS# Precharge | 8 |
| Precharge delay (tRAS) | 21 |
| ACT to ACT Delay (tRRD) | 4 |
| Rank Write To READ Delay | 8 |
| Write To Precharge Delay | 12 |
| Refresh to ACT Delay | 60 |
| Read to Precharge Delay | 6 |
| Static tRead Value | 7 or 8 depending on stability requirements (7 = higher performance) |
| Static tRead Phase Adjust | Auto |
| Command Rate | 1N |
| CPU/PCIEX Clock Driving | 800mV |
| CPU Clock Skew Control | Normal |
| (G)MCH Clock Skew Control | Normal |
| System Voltage Control | Manual |
| DDR3 Overvoltage Control | (+)0.55 |
| PCI-E Overvoltage Control | Normal |
| FSB Overvoltage Control | (+)0.35 |
| (G)MCH Overvoltage Control | (+)0.25V |
| Loadline Calibration | Disabled |
| CPU Voltage Control | Dependant on Processor |
Originally published at https://www.anandtech.com/show/2410 (Wayback Machine).