Archive 1997–2024

abit IP35-Pro: Houston, We Have a Winner

Memory Testing and Overclocking:


The abit IP35-Pro has the second best latency scores of our test units thanks to very aggressive tRD settings. abit's Sandra unbuffered scores are around 2% lower than the ASUS and Gigabyte boards but as we will see, overall performance is still extremely competitive with these boards.

Q6600 9x266

Q6600 8x455 2GB

Q6600 8x450 & 8x455 4GB


We were able to reach a final 8x455FSB overclock with our Q6600. The first 8x455FSB screenshot is with the 2GB memory configuration set at DDR2-1092 at 4-4-4-12 timings. Memory voltage was set to 2.30V although the system ran fine at 2.275V except with Supreme Commander, which, would lock up at any voltage setting under 2.30V. Our CPU voltage was set at 1.50V and was at the absolute limit of our air cooling setup during the POST routine. The one problem we had with the board throughout testing with the Quad Core processors consisted of Vdrop/Vdroop levels of up to .08V under load. With additional cooling and increasing the CPU voltage to 1.53V (1.45V after Vdroop) the board was able to POST and complete our test suite at 8x470FSB.

The 4GB configuration was still able to reach 455FSB but only at a 1:1 memory ratio that resulted in a DDR2-910 speed with 4-4-4-10 memory timings. We were able to drop our memory voltage to 2.250V with this configuration while CPU voltage was dropped to 1.49V resulting in a 1.43V reading under load. We were able to run our memory at the 5:6 ratio but had to drop our FSB settings to 450 and loosen timings to 5-5-5-15. Our test results generally favored this configuration when using 4GB of memory as it exhibited better latencies and throughput compared to the 8x455FSB 4GB setup. A couple of CPU centric benchmarks still favored the slightly higher CPU speed but overall, most applications performed better with the 8x450FSB setup.

E6550 7x550

We were able to reach a final FSB setting of 555 with our E6550. Our 2GB memory configuration was set at 1:1 ratio with 5-4-4-12 timings. This will result in the board setting performance level (Read Delay) to 7 but required memory voltages to be set to 2.275V. The maximum MCH voltage is 1.72V, and 520FSB and higher required that setting with this particular CPU. CPU voltage was set to 1.46V with Vdrop/Vdroop realizing a final 1.41V during normal operation. The highest FSB we have been able to attain with this CPU is 570 on the DFI P35 board.

The overclocking capability of this motherboard is extremely good but more importantly, very easy. The board's stability will start to trail off when you are near its limits so there is feedback from the board before you go over the edge. The board does not overclock quite as well as the DFI P35 TR, Gigabyte GA-P35-DQ6, or the ASUS Blitz series of boards. However, unless you are trying to set overclocking records, the board will satisfy 95% of the users. If we could change one item with the overclocking capabilities, it would be excessive Vdroop with the quad core processors.

Originally published at https://www.anandtech.com/show/2367 (Wayback Machine).