Archive 1997–2024

ZEROtherm BTF90: Sting like a Butterfly?

Scaling of Cooling Performance

The BTF90 performance was average at both stock idle and stock load compared to other top coolers tested at AnandTech. Keeping in perspective that a 92mm fan drives the BTF90 compared to the 120mm fans used on most other coolers, this performance would have to be considered very good. As overclocks are raised, the ZEROtherm exhibits improved performance in the ability to cool the CPU under stress conditions.

Click to enlarge

At 2.93GHz the retail HSF is running at 41C, compared to 30C with the BTF90. This is a delta of 11C. The delta becomes greater as the overclock increases. At 3.73GHz the idle with the retail fan is 56C compared to the Ultra-X at 39C - a delta of 17C. The cooling performance of the BTF90 is much better than the Intel retail cooler at idle, but the ZEROtherm does not reach the same cooling levels measured with the Thermalrights (with a Scythe S-Flex SFF21F fan) or the stock Tuniq 120. The top Thermalright Ultra-120 eXtreme, for example, is at 33C at the same 3.73GHz.

We also need to compare cooling efficiency of the ZEROtherm BTF90 under load conditions to the retail HSF and other recently tested CPU coolers. Load testing can be very revealing of a cooler's efficiency. A basically flat line, particularly form 3.73GHz upward, indicates the cooler is still in its best cooling range. A line that is increasing rapidly indicates a cooler nearing the end of its ability to cool efficiently. Lines which parallel the best coolers over a range of values are indicate that the coolers have similar cooling efficiency.

Click to enlarge

The BTF90 is very efficient in cooling in the 2.93 GHz to 3.73 GHz overclock range. The BTF90 continues on to a highest overclock of 3.83GHz, but the cooling curve is much steeper in this area, suggesting the BTF90 is losing cooling efficiency. The BTF90 falls short of the 3.90GHz to 3.94GHz most of the top coolers in our testing have achieved, but it is also cooling with a smaller fan with a smaller output than the other coolers. It also manages this with relative quiet, as seen in the noise tests.

As stated many times, the overclocking abilities of the CPU will vary at the top, depending on the CPU. This particular CPU does higher FSB speeds than any X6800 we have tested, but the 3.90GHz top speed with the Tuniq is pretty average among the X6800 processors we have tested with Tuniq cooling. A few of the other processors tested with the best air coolers reach just over 4 GHz, but the range has been 3.8 to 4.0GHz. Stock cooling generally tops out 200 to 400 MHz lower, depending on the CPU, on the processors tested in our lab.

Originally published at https://www.anandtech.com/show/2299 (Wayback Machine).