Archive 1997–2024

Zippy Gaming G1 (GSM-6600P): Hybrid or Fence-Sitter?

Primary Side




The inside looks like your typical PSU. Zippy has all of the components of the transient filter stage located in the upper section of the PCB. It looks very crowded and the fan is located directly behind it. The filter stage however looks very good and includes all the expected components.



On the side we see a small Hitachi cap with 330µF and 400V which is rated up to 105°C. The PFC IC is located on the left side of the primary stage.

Secondary Side



The secondary side has another PCB that contains the circuitry for PWM and fan control. The whole area is quite packed and includes a cable-jungle so there is little chance for any airflow to these components. This area will most likely get hotter than the rest of the PSU. The fan is located on the other side along with the heatsinks, and that's where most of the airflow will be present.

One important issue to point out is that the cables are not in any way connected to the housing which makes them quite unstable. If you carry the PSU do not grab it by the cables - not that we would recommend doing so anyway - since there is a slight chance for them to become disconnected from the PCB. Zippy should have attached the cables to the housing with at least a cable tie, just to be safe, and that is a solution that could still be easily implemented.

The Fan




The installed 8cm fan is manufactured by the Japanese company Sanyo Denki. They have very good fans and are famous for high reliability, low noise (not this model), and a good amount of airflow (CFM). The fan pulls the air through the power supply which can potential provide for better control of the airflow. However, a drawback to such an approach is the higher noise levels because the fan is located right at the exit. Etasis power supplies have a similar design, but their fans are installed a bit further inside of the PSU, so they get the pull arrangement for airflow along with lower noise levels.

Originally published at https://www.anandtech.com/show/2293 (Wayback Machine).