Scythe Andy Samurai Master vs. Thermaltake MaxOrb
- Posted in
- Cases/Cooling/PSUs
Noise
For many enthusiasts upgrading cooling the goal is maximum stable overclock, and they will live with the inconvenience of a louder system. For other users silence is the most important factor, and these users will forgo maximum overclocking if that increases system noise levels.
There are virtually no power supplies that do not include a fan. While Zalman and a few others do make an expensive fanless power supplies, we have not seen a fanless unit larger than 500W, or one that would be used for seriously overclocking a system. With that in mind the noise level of the system with all fans turned off except the power supply was measured. The power supply used for the cooling test bed was the OCZ PowerStream 520, which is one of the quieter of the high performance power supplies.
We have also measured the Corsair 620-watt and Mushkin 650-watt power supplies which are reported to be quieter than the OCZ. Both the Corsair and Mushkin are indeed quieter at idle or start up speed. However, as soon as load testing begins and the PSU fan speed kicks up the measured noise level is almost exactly the same as the OCZ PowerStream 520 watt power supply.
We are currently in the process of evaluating "quieter" power supplies for an update to our cooler test bed. We will make changes to that test bed as soon as we are confident in the noise measurements and test procedures with a variable speed quiet PSU. We plan to evaluate additional power supplies and configurations in our upcoming 120mm fan roundup, at which point we will complete the transition to a revised and lower noise cooler test bed.
The noise level of the power supply was 38.3 dB from 24" (61cm) and 47 dB from 6" (152mm). The measured noise level of the test room is 36.4 dB, which would be considered a relatively quiet room with a noise floor slightly below the OCZ PowerStream 520 PSU.
We measured noise levels with the Thermaltake MaxOrb and the Scythe Andy Samurai Master with the stock Scythe fan at its single speed and the embedded MaxOrb fan at Low and High speeds. Results were then compared to the other coolers/fans tested in this category. Measured noise levels in this chart should be considered worst case. Measurements were taken with an open side of a mid tower case 6" and 24" from the HSF. Real world would be a completely closed case resulting in a further reduction in noise.


The measured noise levels at 6" and 24" are below the system noise floor with the quiet Scythe fan on the Andy Samurai Master. The Thermaltake actually specifies even lower noise levels than the Scythe, but at both low and high noise it was above the 24" noise floor at 40.7dbA at low speed and 45.8dbA at high speed. The MaxOrb fan is definitely audible, but the noise is not particularly irritating in frequency. If you are very sensitive to noise you should be aware you will likely hear the MaxOrb fan with an open case.
At the 6" measurement the MaxOrb was below the noise floor at low speed, and significantly above the noise floor of 47dbA at high speed with a measured 52.5dbA. The Tuniq Tower 120 on high, the Zalman 9700 on high, and the Monsoon II Lite stressed were noisier than this, but this is still one of our highest measurements. Again the noise frequencies are well placed and not particularly irritating as there is none of the high-pitched whine that some fans generate, but the MaxOrb is definitely not silent.
For many enthusiasts upgrading cooling the goal is maximum stable overclock, and they will live with the inconvenience of a louder system. For other users silence is the most important factor, and these users will forgo maximum overclocking if that increases system noise levels.
There are virtually no power supplies that do not include a fan. While Zalman and a few others do make an expensive fanless power supplies, we have not seen a fanless unit larger than 500W, or one that would be used for seriously overclocking a system. With that in mind the noise level of the system with all fans turned off except the power supply was measured. The power supply used for the cooling test bed was the OCZ PowerStream 520, which is one of the quieter of the high performance power supplies.
We have also measured the Corsair 620-watt and Mushkin 650-watt power supplies which are reported to be quieter than the OCZ. Both the Corsair and Mushkin are indeed quieter at idle or start up speed. However, as soon as load testing begins and the PSU fan speed kicks up the measured noise level is almost exactly the same as the OCZ PowerStream 520 watt power supply.
We are currently in the process of evaluating "quieter" power supplies for an update to our cooler test bed. We will make changes to that test bed as soon as we are confident in the noise measurements and test procedures with a variable speed quiet PSU. We plan to evaluate additional power supplies and configurations in our upcoming 120mm fan roundup, at which point we will complete the transition to a revised and lower noise cooler test bed.
The noise level of the power supply was 38.3 dB from 24" (61cm) and 47 dB from 6" (152mm). The measured noise level of the test room is 36.4 dB, which would be considered a relatively quiet room with a noise floor slightly below the OCZ PowerStream 520 PSU.
We measured noise levels with the Thermaltake MaxOrb and the Scythe Andy Samurai Master with the stock Scythe fan at its single speed and the embedded MaxOrb fan at Low and High speeds. Results were then compared to the other coolers/fans tested in this category. Measured noise levels in this chart should be considered worst case. Measurements were taken with an open side of a mid tower case 6" and 24" from the HSF. Real world would be a completely closed case resulting in a further reduction in noise.


The measured noise levels at 6" and 24" are below the system noise floor with the quiet Scythe fan on the Andy Samurai Master. The Thermaltake actually specifies even lower noise levels than the Scythe, but at both low and high noise it was above the 24" noise floor at 40.7dbA at low speed and 45.8dbA at high speed. The MaxOrb fan is definitely audible, but the noise is not particularly irritating in frequency. If you are very sensitive to noise you should be aware you will likely hear the MaxOrb fan with an open case.
At the 6" measurement the MaxOrb was below the noise floor at low speed, and significantly above the noise floor of 47dbA at high speed with a measured 52.5dbA. The Tuniq Tower 120 on high, the Zalman 9700 on high, and the Monsoon II Lite stressed were noisier than this, but this is still one of our highest measurements. Again the noise frequencies are well placed and not particularly irritating as there is none of the high-pitched whine that some fans generate, but the MaxOrb is definitely not silent.
Originally published at https://www.anandtech.com/show/2244 (Wayback Machine).