Archive 1997–2024

Cooler Master Hyper 6+: Universal Heatpipe Tower

Noise

For many enthusiasts the goal in upgrading cooling is maximum stable overclock, and they will live with the inconvenience of a louder system. For other users silence is the most important factor, and these users will forgo maximum overclocking if this increase system noise levels. In general the Hyper 6+ can be considered very quiet, which is certainly an improvement from the early models with the louder fan - at least where noise is concerned.

We could not create operating conditions that reliably forced highest speed on the 100mm fan, so we attached a Zalman fan controller and dialed in the highest speed to create that condition. For that reason the stress noise measurements should be considered the worst case measurements - noise that you will not likely ever hear with this cooler.

There are virtually no power supplies that do not have a fan. While Zalman and a few others do make a few expensive fanless power supplies, we have not seen a fanless unit larger than 500W, or one that would be used for seriously overclocking a system. With that in mind the noise level of the system with all fans turned off except the power supply was measured. The power supply used for the cooling test bed was the OCZ PowerStream 520, which is one of the quieter of the high performance power supplies. The noise level of the power supply was 38.3dB from 24" (61cm) and 47dB from 6" (152mm). The measured noise level of the test room is 36.4dB, which would be considered a relatively quiet room with a noise floor slightly below the OCZ PowerStream 520 PSU.

Noise Level - 6

Noise Level - 24

Measured noise levels in this chart should be considered worst case. Measurements were taken with an open side of a mid tower case 6" from the open HSF and 24" from the open HSF. Real world would be a completely closed case with a further reduction in noise.

The noise measurements for the Cooler Master Hyper 6+ were definitely on the quiet side of tested coolers. The 100mm cooling fan on the Cooler Master is extremely quiet at low speeds, within 1 dB or below the noise floor of the test system. It is also among the quietest coolers at higher speeds, and comparable to other high-end units at maximum speed. Considering the Hyper 6+ fan has to work harder at 3600 rpm, it certainly remains a quiet fan. It is also rare than the fan even approaches high speed in day-to-day operation.

The only small complaint we have is that the excellent fan included in the kit is a non-standard 100mm. Buyers would have had a wider range of noise control and performance options had Cooler Master chosen a standard fan size like 120mm or 92mm.

Originally published at https://www.anandtech.com/show/2173 (Wayback Machine).