Archive 1997–2024

Shuttle SN27P2 SFF: AM2 gets the Tiny Treatment

Construction and Assembly

While the external changes are mostly cosmetic, the changes to the internal layout had a bit more of an impact.

Click to enlarge

The P series featured a mostly tool-less design. You still needed a screwdriver in order to change out the expansion cards and to remove the screws securing the CPU heatsink. Other than those two areas, though, you could completely assemble/disassemble the P series SFFs without touching another tool. In order to address problems some users experienced when transporting their computers, Shuttle has decided to use hard drive trays instead of the mounting rails in the P2 chassis. This means eight screws per hard drive, plus four more for the optical drive, so now it takes a bit more time to assemble a system using the new case. The flip side is that you get a sturdier, more flexible design.

Click to enlarge

While we never had a problem with the plastic mounting rails, the plastic clips on the drive rails could potentially wear out after frequent hardware swaps, and some users reported that their SATA cables would come loose if they bumped the computer. We're not sure who goes around shaking or dropping their computer anyway, but the end result is that convenience has been slightly sacrificed for compatibility and durability, which isn't a terrible decision on Shuttle's part. (Personally, I still prefer the drive rails, as I'm more likely to swap hardware than to transport a computer, but that's no more representative of the typical computer user than people who attend weekly LAN parties.)

Click to enlarge

Other than the change from drive rails to the new drive cages, the internals of the P2 chassis are essentially identical to the P series. We did encounter one difficulty with the new layout, though this may be due to the pre-release nature of our test system. The SATA cables have right angle connectors on the hard drive end, and connecting them to the drives requires some bending of the cable as well as a decent amount of effort. The power cables for the hard drives are the same as on the P series, and frankly we wish the SATA cables were the same as well.

Click to enlarge

Shuttle continues to use their fourth generation Integrated Cooling Engine (4G ICE) for the P2 chassis. The heatsink has a copper base plate with heatpipes connected to a vertical radiator, in addition to a more traditional block of aluminum fins directly above the processor. Two 4-pin temperature controlled fans are used to vent air over this area, the smaller is 70mm in diameter and the larger is 92mm. The PSU also has a fan, and additional cooling at the top-rear of the case is provided by two more 60mm fans. These last two fans also help to cool the hard drive(s), and the BIOS allows you to set the fan speed for these. In practice, the solution continues to work well, though we would prefer a "smart" fan speed option for the rear fans as opposed to a static setting.

Click to enlarge

The above images basically show the assembly process of our test system. We didn't encounter any difficulties until we came to the DVD drive. Our first attempt at installation resulted in it not lining up properly with the eject button on the front of the case, so we had to remove the drive cages and try again. We also switched to a shorter DVD drive, as the old DVD/CD-RW combo drive shown in the above picture created a very tight fit. We would advise you to install your optical drive with the cage inside the case, as that's the easiest way to make sure everything lines up properly.

Click to enlarge

Once assembled, the BIOS configuration and operating system installation can proceed. We encountered no difficulties in this area, though if you wish to install to a RAID 0/1 setup you will need to use a floppy disk to provide the necessary drivers.

Originally published at https://www.anandtech.com/show/2038 (Wayback Machine).