Archive 1997–2024

HTPC 4-Way Roundup

Antec Overture II (cont’d)

After putting the optical drive in its cage, we decided to put it in the case first. This cage, in particular, fits in very easily and latches in place quickly and solidly.


Click to enlarge.

Here, we see another need for the specialized power supply, as the power cord needs to be routed out the same side of the unit from which the leads come out. What’s also noteworthy in this photo is the illustration of how easy it is to route the cables coming from the front panel of the case.


Click to enlarge.

Next, we laid the motherboard in place, and simply to get a shot of the bottom of the included power supply, we lifted it in this picture from its normal position.


Click to enlarge.

It fits! Even with our oddly-placed IDE connector, the Overture II allows barely enough space between the motherboard and power supply to accommodate those rare motherboards out there.


Click to enlarge.

With the motherboard in place, we put the rear hard drive cage in next, and put two more of the included screws (designed to go through the rubber grommets) into the hard drive in the picture. The cage slides securely on rails into position and is held in place by the two mounting points visible towards the top of the picture.


Click to enlarge.

Finally, after securing the rear hard drive cage and connecting all the cables, which was no easy task considering the massive amount of cables coming out of the included power supply, it was time to attach our video card. Unfortunately, this is where we ran into a relatively ugly problem with the Overture II. The PCI slot covers have an incredibly cheap feel to them, and short of prying them off with a pair of pliers, they are quite difficult to remove. If one wasn’t very careful, he could get cut wrestling with one of these.

The card did plug in though without problems, and we then put the front 3½” cage in place over the power supply and the install was completed. Like the Mstation, the install was straight-forward, but for the most part, the components didn’t fit quite as well.


Click to enlarge.

When turned on, a plastic ring surrounding the power button glows blue for a subtle effect on the front of the case.


Click to enlarge.

After finishing up with the Antec case, we noticed one other problem. When installing the lid, it must have been a little bit off a couple of times, and even with the brand new coat, a sharp enough edge scraped the paint off the top edge of the side.


Click to enlarge.

This is simply something that happens when ideas like a glossy paint job and a removable top cover (as opposed to a three-side cover) come together. Regardless, a careful user really has no reason to let this affect their opinion of the case.

Originally published at https://www.anandtech.com/show/1868 (Wayback Machine).