Archive 1997–2024

Intel 945P Motherboards: Going from Hopeless to Enthusiastic

FOXCONN 945P7AA-8EKRS2: Overclocking

FSB Overclocking Results

Front Side Bus Overclocking Testbed
Processor: Pentium 4 Prescott LGA 775
820 Dual Core 2.8GHz
CPU Voltage: 1.4500V (1.3000V default)
Memory Settings: 4-4-4-15 at 667MHz
Memory Voltage: 1.9V
NorthBridge Voltage: 1.50V
SouthBridge Voltage: 1.05V
Cooling: Intel 840EE Heat Sink
Power Supply: OCZ Power Stream 520
Maximum CPU OverClock: 255fsb x 14 (3570MHz) +27%

This board is a decent overclocker, considering its limitations to running our memory at 1.9V. At this overclock setting, the system was able to complete all of our benchmark test suites and also run Prime95 and SuperPI without issue. We were able to overclock the FSB to 258 at the14x multiplier, which resulted in CPU operation of 3612MHz, but we were unable to complete the benchmark test suite. However, at this setting, the board was stable enough to complete most of the gaming benchmarks.

Memory Stress Tests

Memory stress tests look at the ability of the Foxconn 945P7AA-8EKRS2 to operate at the officially supported memory frequencies of 667MHz DDR2 at the best performing memory timings that the Corsair CM2X512A-5400UL revision 1.3 will support.

Foxconn 945P7AA-8EKRS2
Stable DDR667 Timings - 2 DIMMs
(2/4 slots populated - 1 Dual-Channel Bank)
Clock Speed: 200MHz (800FSB)
Timing Mode: 667MHz - Default
CAS Latency: 4
RAS to CAS Delay: 4
RAS Precharge: 4
RAS Cycle Time: 15
Voltage: 1.9V

The Foxconn 945P7AA-8EKRS2 was completely stable with 2 DDR2 modules in Dual-Channel at the settings of 4-4-4-15 at 1.9V. The inability to support memory voltages higher than 1.9V is an issue that Foxconn needs to address if they are to be taken seriously in the enthusiast market.

We will now install all four available memory slots that are usually more strenuous on the memory subsystem than testing 2 DDR2 modules on a motherboard.

Foxconn 945P7AA-8EKRS2
Stable DDR667 Timings - 4 DIMMs
(4/4 slots populated - 2 Dual-Channel Banks)
Clock Speed: 200MHz (800FSB)
Timing Mode: 667MHz - Default
CAS Latency: 4
RAS to CAS Delay: 5
RAS Precharge: 5
RAS Cycle Time: 15
Voltage: 1.9V

The Foxconn 945P7AA-8EKRS2 was completely stable with 4 DDR2 modules in Dual-Channel at the settings of 4-5-5-15.

Originally published at https://www.anandtech.com/show/1857 (Wayback Machine).