Archive 1997–2024

DFI LANParty UT RDX200: ATI’s Crossfire AMD for the Bleeding Edge

Overclocking: DFI LANParty UT RDX200

 DFI LANParty UT RDX200
Overclocking Testbed
Processor(s): Athlon 64 4000+
(2.4GHz, 1MB Cache)
CPU Voltage: 1.425V (default 1.40V)
Cooling: Thermaltake Silent Boost K8 Heatsink/Fan
Power Supply: OCZ Power Stream 520W
Memory: OCZ PC3200 Platinum Rev. 2
(Samsung TCCD Memory Chips)
Hard Drive: Seagate 120GB 7200RPM SATA 8MB Cache
Maximum OC:
(Standard Ratio)
245x12 (4x HT, 2.5-3-3-10)
2940MHz (+22.5%)
Maximum FSB:
(Lower Ratio)
305 x 9 (3x HT, 1T)
(2718MHz, 2 DIMMs in DC mode)
(+53% Bus Overclock)

The DFI matched the highest stock speed overclock that we have achieved with this Clawhammer 130nm processor. There is little to complain about with this kind of stock overclocking with this CPU.

Lowering the multiplier to reach the highest CPU clock was a bit more difficult. While it was easy to reach a stable 270 with the default (mostly AUTO) memory timings in BIOS, getting to the eventual 305 proved more of a challenge. The design team tells us that the RDX200 was optimized for Crucial Ballistix 1GB DIMMs and not our standard OCZ TCCD DIMMs. We finally reached a stable 305 setting with the following settings:

  • Tref (Refresh Period) - 2592
  • DRAM Drive Strength - 7
  • DRAM Data Drive Strength - 2
  • Max Asynch Latency - 9
  • Read Preamble Time - 6.5
The other settings were left at default for TCCD. HT, main memory timings, and voltages are in the above chart.

When we discussed results with the DFI Design Engineer, we were told that our results were typical of what could be expected on this. The highest clock does not reach to 315 to 318 as a few other boards have because of the compromises made to achieve reliable operation with 4 double-sided DIMMs at 1T. However, most boards should be able to reach a 300 to 310 Clock frequency in overclocking with appropriate ratios.

Originally published at https://www.anandtech.com/show/1828 (Wayback Machine).