Archive 1997–2024

915 Motherboard Roundup: Socket 775 for the Rest of Us


Albatron PX915P Pro: Overclocking and Stress Testing

Front Side Bus Overclocking Testbed
Processor: Pentium 4 Prescott LGA 775
560 ES (2.8GHz-3.6GHz)
CPU Voltage: 1.425V (1.3675V default)
Cooling: Thermaltake Jungle 502
Power Supply: OCZ Power Stream 520
Maximum CPU OverClock: 222x18 (3996MHz) +11%
Maximum FSB OC: 250FSB x 14 (+25%)

The Albatron 915P Pro was an above-average performer in our overclock tests, reaching 3996MHz at the stock 18X multiplier. At the Speedstep 14X ratio, the Albatron performed fine to a 250 FSB setting. Above 250, the SATA drive disappeared and it was not possible to boot at higher FSB settings. Since the Albatron continued to boot to the hard drive initialization stage at higher FSB, the Albatron may reach higher overclocks with an IDE drive.

A few weeks after the launch of the Intel 915/925X chipsets, Albatron made some claims that the key to high overclocks on the 915 chipset was increasing Northbridge voltage. We did not find that further increases in NB voltage allowed any higher overclock with SATA drives - 250 was the limit for our components on the Albatron. For more information on how others manage to overclock the 915/925X, please check Breaking Intel's Overclock Lock: The REAL Story.

Memory Stress Test Results:

The memory stress test measures the ability of the Albatron PX915P Pro to operate at its officially supported memory frequency (400MHz DDR), at the best performing memory timings that OCZ PC4200 Platinum Rev. 2 will support. Memory stress testing was conducted by running DDR at 400MHz (stock 1:1 ratio) with 2 DIMM slots operating in Dual-Channel mode.

Stable DDR400 Timings - 2 DIMMs
(2/4 DIMMs - 1 Dual-Channel Bank)
Clock Speed: 200MHz
Timing Mode: 1:1 (200:200 - Default)
CAS Latency: 2.0
Bank Interleave: Auto
RAS to CAS Delay: 2
RAS Precharge: 2
Cycle Time (tRAS): 5

The Albatron was completely stable with 2 DIMMs in Dual-Channel at DDR400 settings of 2-2-2-5 at 2.6V default voltage. These are the fastest settings available with the DDR400 test DIMMs.

Filling all four available memory slots is more strenuous on the memory subsystem than testing 2 DDR2 modules on a motherboard.

Stable DDR400 Timings - 4 DIMMs
(4/4 DIMMs - 2 Dual-Channel Banks)
Clock Speed: 200MHz
Timing Mode: 1:1 (200:200 - Default)
CAS Latency: 2.0
Bank Interleave: Auto
RAS to CAS Delay: 2
RAS Precharge: 2
Cycle Time (tRAS): 5

The system was stable with 4 DIMMs at the same aggressive settings used for 2 DIMMs.

Originally published at https://www.anandtech.com/show/1561 (Wayback Machine).