Archive 1997–2024

915 Motherboard Roundup: Socket 775 for the Rest of Us


Foxconn 915A01: Overclocking and Stress Testing

FSB Overclocking Results

Front Side Bus Overclocking Testbed
Processor: Pentium 4 Prescott LGA 775
560 ES (2.8GHz-3.6GHz)
CPU Voltage: 1.425V (1.3875V default)
Cooling: Thermaltake Jungle 502
Power Supply: OCZ Power Stream 520
Maximum CPU OverClock: 216x18 (3888MHz) +8%
Maximum FSB OC: 216FSB x 14 (+8%)

The whole reason for FSB and voltage adjustments is what they can actually do for the board's performance. As you can see, Foxconn has made no efforts at all to provide overclocking above and beyond the 10% level. In fact, the best that we could do at any ratio was an 8% OC to 216. This is the worst overclocking performance of any 915 board in the roundup. The Foxconn is a decent performer at stock speeds, but if you are looking for a 915 overclocking solution, you really need to look elsewhere or learn a great deal about using PCI speed adjustments to reach higher overclocks.

Memory Stress Test Results:

The memory stress test measures the ability of the Foxconn 915A01 to operate at its officially supported memory frequency of DDR2-533, at the best performing memory timings that Crucial/Micron PC2-4300U will support. Memory stress testing was conducted by running DDR2 at 533MHz (stock 3:4 ratio) with 2 DIMM slots operating in Dual-Channel mode.

Stable DDR533 Timings - 2 DIMMs
(2/4 DIMMs - 1 Dual-Channel Bank)
Clock Speed: 266MHz
Timing Mode: 3:4 (200:266 - Default)
CAS Latency: 3.0
Bank Interleave: Auto
RAS to CAS Delay: 3
RAS Precharge: 3
Cycle Time (tRAS): 10*
*SPD (Auto) timings for DDR2 are normally 4-4-4-12 at DDR2-533. A tRAS setting of 12 is normal. We ran a series of tests to measure memory bandwidth, and found that the tRAS setting made very little difference in the performance of DDR2. The most effective range of tRAS was 8 to 13 for DDR2 on the 925X chipset, so a tRAS of 10 was chosen for benchmarking.

The Foxconn matched the other boards in the 915 roundup in being able to run with complete stability at 3-3-3-10 timings with two DDR2 DIMMs. The 915A01 was completely stable at these timings at the default 1.8V.

Filling all four available memory slots is more strenuous on the memory subsystem than testing 2 DDR2 modules on a motherboard.

Stable DDR533 Timings - 4 DIMMs
(4/4 DIMMs - 2 Dual-Channel Banks)
Clock Speed: 266MHz
Timing Mode: 3:4 (200:266 - Default)
CAS Latency: 4.0
Bank Interleave: Auto
RAS to CAS Delay: 4
RAS Precharge: 3
Cycle Time (tRAS): 10
Command Rate: N/A

When all 4 DDR2 slots are filled, the Foxconn required slightly slower timings than the top boards in the roundup, requiring 4-4-3 timings for complete stability instead of the 4-3-3, which worked well on most 915 boards. This is the same memory pattern seen with the 925X Foxconn board when we tested that board.

Originally published at https://www.anandtech.com/show/1561 (Wayback Machine).