Archive 1997–2024

Enermax Sea Hawk


Internal Design

The Sea Hawk's simple outer look is carried to the inside design, but it is carried well. Though not completely tool-less, Enermax has designed the case to look and function in the simplest manner.




Click to enlarge.


Starting at the front of the case, the drive bays are all attached to the chassis. We did have one question on the construction of the bays - why was it not cut from a single piece of steel? After the third 5-1/4" drive bay, the steel seems to be cut off and continued to form the casing for the top 5-1/4" portion of drive bays.




Click to enlarge.


Looking closer, we saw that the other side of those bays was basically the steel panel on which the motherboard sits. This design made efficient use of the material, but cosmetically, could have been improved upon; maybe using one piece of steel to wrap around to the other side.




Click to enlarge.


Another thing that we noticed with the drive bays was the platforms, which were folded over for the drives to sit upon. Since the metal was about 0.7mm thick, the platforms seemed to bend more easily than other 0.8mm models that we have looked at. Though the platforms did provide some support, Enermax would have been better off doing away with them, and in turn, reducing sharp edges.




Click to enlarge.


As for sharp edges, even though Enermax tried to solder over and dull any of the edges, many remained throughout the Sea Hawk. Attending to all of the edges in a chassis design may be difficult, but the most attention should be paid to those things that are exposed to human interaction no matter where they are in the case.

Originally published at https://www.anandtech.com/show/1427 (Wayback Machine).