Archive 1997–2024

The Birth of an Abit NF7 - A Factory Tour


Solder

After going through the assembly line, the components just placed on the motherboard are only tacted in place. In order for their transformation to be complete, they must go through an industrial oven so the solder bonds correctly to the board. This is actually the second oven on the production line; the first is used right after SMT.




Click to enlarge.


This is actually not an ordinary oven, its a wave solder machine. Wave solder ovens run the motherboard over a molten solder bath in order to melt the fastened components onto the board. You can see a small clip below of the motherboard passing through a final phase in the device. There are two other wave solder machines at Rolly that are completely lead free. Lead free machines use similar assembly techniques, but the solder does not contain any lead (EU legislation requires all electronics imported into the union to be lead-free by 2005). The ovens on those two lines run at different temperatures and look slightly different.




Right click to download.


After the oven, a few workers spot solder larger components, which need a little extra to hold in place. Heatsinks and stickers are also placed on the motherboard. Everything else from this point until packaging is quality assurance.

Just like the ECS Shen Zhen facility, each motherboard is completely assembled and booted up to make sure it passes the first stage of quality control. Several custom benchmarks are run, and the system stays on for about two minutes. Each worker works on two motherboards at a time, assembling one while the other is running system diagnostics. It takes less than a minute for each worker to build the entire system.




Click to enlarge.




Click to enlarge.


These boards are only tested once. The workers here will bin bad motherboards into a container, which goes back to the original lab with the oscilliscopes. Good motherboards continue down the line, get scanned into the Oracle database, and are then stamped "OK" to continue on to stress testing or packaging.

However, these motherboards are still not done yet. Out of each batch of 1000 motherboards, 32 are chosen randomly for environmental stress testing, plus a 168-hour burn in. A majority of the other 968 motherboards in the batch are placed into a different testing facility where they will be burned in for 24 hours. Burn in is simply the process of running a benchmark software on the system continuously for an allocated amount of time. Additionally, 10 other motherboards per model per day are selected off the final assembly line and are fully hand-assembled into a PC. Several lucky workers spend the rest of the day making sure UT2K4 (among other software) works correctly with the sampled motherboard.

Originally published at https://www.anandtech.com/show/1350 (Wayback Machine).