Archive 1997–2024

Socket 940 Roundup: Motherboards for the Athlon64 FX


Asus SK8V: Stress Testing

We performed stress tests on the VIA-chipset Asus SK8V in these areas and configurations:

1. Chipset and motherboard stress testing, conducted by running the FSB at 213MHz at default voltage. We also ran a few stability tests at the highest overclock of 2475GHz at 1.625V.
2. Memory stress testing, conducted by running the Registered ECC Memory at 400MHz with 2 Dual-Channel (1 bank) DIMM slots filled, and at 400MHz with all 4 Dual-Channel (2 bank) DIMM slots filled at the lowest memory timings possible with Mushkin Registered ECC 3200 memory. Since the Athlon64 FX does not require ECC for proper operation, all memory tests were run with ECC disabled.

Front Side Bus Stress Test Results:

We ran a full range of stress tests and benchmarks to ensure that the Asus SK8V was absolutely stable at the overclocked speed at default voltage. This included Prime95 torture tests, and the addition of other tasks — data compression, various DX8 and DX9 games, and apps like Word and Excel — while Prime95 was running in the background. 213MHz was the highest overclock that we were able to achieve at default voltage; 2475MHz was the highest overclock that we could achieve by raising the CPU voltage or Hammer VID to 1.625V. Raising the voltage to 1.65V did not improve overclocking or stability.

Memory Stress Test Results:

This memory stress test simply tests the ability of the SK8V to operate at its officially supported memory frequency (400MHz DDR) at the lowest supported memory timings that our Mushkin High Performance ECC Registered Modules will support. The Registered Modules were run at SPD timings:

Stable DDR400 Timings — 2 DIMMs
2/4 DIMMs populated — 1 DC bank
Clock Speed: 200MHz
Timing Mode: 128-bit DC
CAS Latency: 2.0
Bank Interleave: N/A
RAS to CAS Delay: 3T
RAS Precharge: 6T
Precharge Delay: 2T
Command Rate: Auto
ECC: Disabled

Two Double-Sided 512MB DIMMs of our standard Mushkin ECC Registered ran with no problem in the SK8V at the aggressive SPD timings and default memory voltage. However, for best stability we needed to raise the memory voltage to 2.6V. At that setting, all testing at 2-2-3-6 was completely stable.

Filling all available memory banks is more strenuous on the memory subsystem than testing 2 DIMMs, but we had no problem running with 4 matching DIMMs installed providing 2 Dual-Channel Banks.

Stable DDR400 Timings — 4 DIMMs
4/4 DIMMs populated — 2 DC bank
Clock Speed: 200MHz
Timing Mode: 128-bit DC
CAS Latency: 2.0
Bank Interleave: N/A
RAS to CAS Delay: 3T
RAS Precharge: 6T
Precharge Delay: 2T
Command Rate: Auto
ECC: Disabled

The required memory timings with 4 DIMMs were the same as 2 DIMMs, the fastest 2-2-3-6 SPD timings of the Mushkin Registered memory. For best stability, a memory voltage setting of 2.6V was required, the same setting needed for best stability with 2 DIMMs.

Prime95 torture tests were successful at the timings listed in the above charts. We also ran ScienceMark (memory tests only) and Super Pi. None of the three stress tests created any stability problems for the Asus SK8V at these memory timings and standard memory voltage.

Originally published at https://www.anandtech.com/show/1210 (Wayback Machine).