Intel's E7205: Granite Bay Hits the Streets
- Posted in
- Motherboards
Tyan S2662: Board Layout
There weren't too many issues with the S2662's layout.
In the Tyan S2662's case, the ATX (20-pin) connector is nicely placed on the right-hand side of the motherboard. This is the best place to position the ATX connector, expect that we would have liked it just a bit higher by an inch or so. This makes the installation/uninstallation of the HSF as well as any other components much easier, since the bulky ATX wires aren't obstructing your path.
There are a total of four fan headers on this motherboard, all of them positioned well. There are two fan headers each located on opposite ends of the motherboard that are positioned well enough sp that you won't have to worry about maneuvering wires inside your case. The other two fan headers are located at the top. One them, the CPU fan header is located so that we are able to unhook the CPU fan line without having to tug on the wires themselves. The other fan header is located on the opposite side of the CPU clamps, right where it should be. This way, if your case supports it, you can have a fan at the top of the case pushing air out and not have to worry about positioning the fan wires anywhere special.
The ATX12V connector is predictably placed on the left-hand side of the motherboard near the I/O ports. This location isn't ideal at all, and not just because it's on the wrong side of the motherboard but also because it's so low down on the motherboard. By placing the ATX12V connector in this particular position, you are unable to move the ATX12V line away from blocking the uninstallation of the HSF due to the fact that the ATX12V is placed so low on the motherboard and also because the ATX12V is relatively short (otherwise, if it weren't so short, we wouldn't be complaining about how low the ATX12V is being placed on the board). Still, this isn't just regulated to Tyan, as most motherboard manufacturers position the ATX12V this way.
You should have no worries about the placement of the Primary and Secondary IDE connectors, since they are close to the DIMM slots, which are located above the AGP slot. By positioning the Primary and Secondary IDE connectors (and Floppy connector) this way, we avoid the difficulty of having to extend IDE cables to reach the uppermost bays of a large ATX case. We also completely avoid cable entanglement with the video card by having these connectors placed above the AGP slot area.
The distance between the DIMM connectors and AGP slot is far enough apart from each other so that we don't have to uninstall the video card if we wanted to install/uninstall memory. This is a very welcome feature, as it is always a plus if a DIYer can cut down on some of the more mindless "busy work" activities of building a computer (like connecting a keyboard, mouse or monitor for example).
There are two USB 2.0 headers located towards the bottom of the motherboard, but not all the way down at the edge and towards the PCI slots as we would have liked. With this positioning, it's difficult to tell if Tyan has made troublesome to maneuver USB bracket wires. For your reference, Tyan doesn't include any USB brackets with their S2662 motherboard.
Originally published at https://www.anandtech.com/show/1033 (Wayback Machine).