QNIX QX2710 LED DPmulti True10 Review
sRGB Test Bench
All calibration measurements are done using SpectraCal’s CalMAN 5.3 software with a custom workflow. Measurements are done using a C6 colorimeter that is first profiled against an i1Pro spectrometer to ensure accurate results. There are two sets of targets we use. Pre-Calibration and our first calibration aim for 200 cd/m^2 with an sRGB gamut and a gamma of 2.2. This is a common real-world setting for a display. The final target changes the white level to 80 cd/m^2 and the gamma curve to the tougher AdobeRGB standard.
|
Pre-Calibration |
Post-Calibration, 200 cd/m^2 |
Post-Calibration, 80 cd/m^2 |
|
| White Level (cd/m^2) | 204.1 | 201.0 | 84.3 |
| Black Level (cd/m^2) | 0.275 | 0.281 | 0.131 |
| Contrast Ratio | 742:1 | 716:1 | 644:1 |
| Gamma (Average) | 1.90 | 2.17 | 2.45 |
| Color Temperature | 6702K | 6629K | 6506K |
| Grayscale dE2000 | 2.74 | 0.44 | 0.81 |
| Color Checker dE2000 | 3.37 | 1.53 | 1.65 |
| Saturations dE2000 | 2.41 | 1.42 | 1.50 |
For this review I’ve switched from taking 21 measurement points to taking 256 levels for grayscale. It provides a much better level of detail than before. Color measurements can’t be measured at the same level of detail, but I do measure them as much as possible.
Using the "Warmish" color temperature setting, we see a good RGB balance before calibration. What isn’t as good is the gamma point, which starts out at 1.6, rises up to 2.0 and then falls down quickly at the top end. This causes crushing of highlights, where values from 90%-100% will look almost identical, and causes shadows to be washed out as well. Colors also have errors with colors on the Green-Yellow-Red side of the CIEuv chart being over-saturated. This also causes the skin tones to be exaggerated.
Post-calibration at 200 cd/m2 the RGB balance is improved but more importantly the gamma is far improved. The gamma is so far off the 2.2 target above 90% that we can’t fully correct it here, but calibration does a good job of fixing it overall. The dE2000 errors fall and are all below 2.0 now with an average of 0.44 that is very good. Color errors improve but there is still a lot of over-saturation in oranges, yellows, greens, and reds that cause visible issues. The lower half of the color gamut is much more accurate.
When we target 80 cd/m2 we see more issues with the gamma, as the lower light output provides us less range to fix the gamma through the hardware LUTs. The grayscale dE2000 is higher as a result but still below 2.0 everywhere. Colors have the same issues, as the green line is hidden behind the yellow line on the saturations chart, but it is otherwise almost the same as it is with 200 cd/m2.
The pre-calibration numbers are okay for the QNIX, but the main thing that holds it back is the gamma preset it utilizes. It makes it hard to hit the gamma target of 2.2 that we look for and means you can see some highlight clipping, even after calibration.
Originally published at https://www.anandtech.com/show/7931/qnix-qx2710leddport-review (Wayback Machine).

















