MyDigitalSSD SMART & BP3 mSATA SSD Review
Performance Over Time & TRIM
As the SMART is a SandForce drive with the stock firmware, I decided not to test its TRIM performance because we have tested that so many times, the latest being our article on SandForce TRIM issue. Hence this part will only cover the BP3 but since it's a new, untested controller, this data should be rather interesting. Let's start with HD Tach ran on a secure erased drive:
For our torture test, I filled the drive with sequential data and hammered it with 4KB random writes (100% LBA space, QD=32) for 40 minutes:
Performance is actually fairly good. The worst drop is around 70MB/s right at the beginning but after about half of the LBAs have been written with sequential data, the average data rate is around 200MB/s. Part of the cause for this is the fact that the BP3 has slow random write performance, which means it will write less data to the drive than what faster drives would, resulting in a less fragmented drive.
Next I secure erased the drive, filled it and tortured it again and TRIM'ed after torture:
TRIM performance is rather dubious. Performance is definitely better than without TRIM but it's still far from clean state performance. I have a feeling that the controller itself is not very powerful so it may simply not be able to do garbage collection on all the blocks without some idle time between torture and HD Tach run (I immediately TRIM'ed the drive after torture and began the HD Tach run). It would explain why the performance is over 300MB/s for a large part of the drive. The controller may have cleaned some of the blocks and the first writes go there but in the end it faces a situation where it has to read-modify-write because all blocks are full, and write performance drop to figures similar to after torture test.
Originally published at https://www.anandtech.com/show/6527/mydigitalssd-smart-bp3-msata-ssd-review (Wayback Machine).


