Archive 1997–2024

Gigabyte X79S-UP5 WiFi Review: Ultra Durable 5 Meets the C606 Chipset

USB Speed

For this benchmark, we run CrystalDiskMark to determine the ideal sequential read and write speeds for the USB port using our 240 GB OCZ Vertex3 SSD with a SATA 6 Gbps to USB 3.0 converter.  Then we transfer a set size of files from the SSD to the USB drive using DiskBench, which monitors the time taken to transfer.  The files transferred are a 1.52 GB set of 2867 files across 330 folders – 95% of these files are small typical website files, and the rest (90% of the size) are the videos used in the Sorenson Squeeze test. 

USB 2.0 Sequential Read Speed

USB 2.0 Sequential Write Speed

USB 2.0 Copy Test

As USB 2.0 comes from the chipset, not much changes between Z77 and X79.

USB 3.0 Sequential Read Speed

USB 3.0 Sequential Write Speed

USB 3.0 Copy Test

For USB 3.0, we are split between Z77 which uses the chipset, and X79 which uses controllers.  On the ASUS we had ASMedia controllers, on the ASRock X79 Extreme11 it was Texas Instruments, and we have VIA USB 3.0 to deal with on the X79S-UP5.  While the Via perform better than the TI, they still lag behind ASMedia.

SATA Testing

We also use CrystalDiskMark for SATA port testing on a C300 drive.  The sequential test (incompressible data) is run at the 5 x 1000 MB level.  This test probes the efficiency of the data delivery system between the chipset and the drive, or in the case of additional SATA ports provided by a third party controller, the efficiency between the controller, the chipset and the drive.

SATA 3 Gbps Sequential Read Speed

SATA 3 Gbps Sequential Write Speed

SATA 6 Gbps Sequential Read Speed

SATA 6 Gbps Sequential Write Speed

Nothing odd to report in our SATA testing - SATA write speeds on X79 lag behind Z77 as a general rule.

DPC Latency

Deferred Procedure Call latency is a way in which Windows handles interrupt servicing.  In order to wait for a processor to acknowledge the request, the system will queue all interrupt requests by priority.  Critical interrupts will be handled as soon as possible, whereas lesser priority requests, such as audio, will be further down the line.  So if the audio device requires data, it will have to wait until the request is processed before the buffer is filled.  If the device drivers of higher priority components in a system are poorly implemented, this can cause delays in request scheduling and process time, resulting in an empty audio buffer – this leads to characteristic audible pauses, pops and clicks.  Having a bigger buffer and correctly implemented system drivers obviously helps in this regard.  The DPC latency checker measures how much time is processing DPCs from driver invocation – the lower the value will result in better audio transfer at smaller buffer sizes.  Results are measured in microseconds and taken as the peak latency while cycling through a series of short HD videos - under 500 microseconds usually gets the green light, but the lower the better.

DPC Latency Maximum

The DPC result for the X79S-UP5 was a little odd.  Initially it was to do with EasyTune 6 interfering with the result, giving a value often 20x that shown here.  However when it was turned off, the DPC seemed to have other issues:

This DPC behavior is quite odd, suggesting that something onboard is polling the CPU by default. 

Originally published at https://www.anandtech.com/show/6231/gigabyte-x79sup5-wifi-review-ultra-durable-5-meets-the-c606-chipset (Wayback Machine).