Archive 1997–2024

Bulldozer for Servers: Testing AMD's "Interlagos" Opteron 6200 Series

Benchmark Configuration

Since AMD sent us a 1U Supermicro server, we had to resort to testing our 1U servers again. That is why we went back to the ASUS RS700 for the Xeon. It is a bit unfortunate as on average 1U servers have a relatively worse performance/watt ratio than other form factors such as 2U and blades. Of course, 1U still makes sense in low cost, high density HPC environments.

Supermicro A+ server 1022G-URG (1U Chassis)

CPU Two AMD Opteron "Bulldozer" 6276 at 2.3GHz
Two AMD Opteron "Magny-Cours" 6174 at 2.2GHz
RAM 64GB (8x8GB) DDR3-1600 Samsung M393B1K70DH0-CK0
Motherboard SuperMicro H8DGU-F
Internal Disks 2 x Intel SLC X25-E 32GB or
1 x Intel MLC SSD510 120GB
Chipset AMD Chipset SR5670 + SP5100
BIOS version v2.81 (10/28/2011)
PSU SuperMicro PWS-704P-1R 750Watt

The AMD CPUS have four memory channels per CPU. The new Interlagos Bulldozer CPU supports DDR3-1600, and thus our dual CPU configuration gets eight DIMMs for maximum bandwidth.

Asus RS700-E6/RS4 1U Server

CPU Two Intel Xeon X5670 at 2.93GHz - 6 cores
Two Intel Xeon X5650 at 2.66GHz - 6 cores
RAM 48GB (12x4GB) Kingston DDR3-1333 FB372D3D4P13C9ED1
Motherboard Asus Z8PS-D12-1U
Chipset Intel 5520
BIOS version 1102 (08/25/2011)
PSU 770W Delta Electronics DPS-770AB

To speed up testing, we tested with the Intel Xeon and AMD Opteron system in parallel. As we didn't have more than eight 8GB DIMMs, we used our 4GB DDR3-1333 DIMMs. The Xeon system only gets 48GB, but this is no disadvantage as our benchmark with the highest memory footprint (vApus FOS, 5 tiles) uses no more than 36GB of RAM.

We measured the difference between 12x4GB and 8x8GB of RAM and recalculated the power consumption for our power measurements (note that the differences were very small). There is no alternative as our Xeon has three memory channels and cannot be outfitted with the same amount of RAM as our Opteron system (four channels).

We chose the Xeons based on AMD's positioning. The Xeon X5649 is priced at the same level as the Opteron 6276 but we didn't have the X5649 in the labs. As we suggested earlier, the Opteron 6276 should reach the performance of the X5650 to be attractive, so we tested with the X5670 and X5650. We only tested with the X5670 in some of the tests because of time constraints.

Common Storage System

For the virtualization tests, each server gets an adaptec 5085 PCIe x8 (driver aacraid v1.1-5.1[2459] b 469512) connected to six Cheetah 300GB 15000 RPM SAS disks (RAID-0) inside a Promise JBOD J300s. The virtualization testing requires more storage IOPs than our standard Promise JBOD with six SAS drives can provide. To counter this, we added internal SSDs:

  • We installed the Oracle Swingbench VMs (vApus Mark II) on two internal X25-E SSDs (no RAID). The Oracle database is only 6GB large. We test with two tiles. On each SSD, each OLTP VM accesses its own database data. All other VMs (web, SQL Server OLAP) are stored on the Promise JBOD (see above).
  • With vApus FOS, Zimbra is the I/O intensive VM. We spread the Zimbra data over the two Intel X25-E SSDs (no RAID). All other VMs (web, MySQL OLAP) get their data from the Promise JBOD (see above).

We monitored disk activity and phyiscal disk adapter latency (as reported by VMware vSphere) was between 0.5 and 2.5 ms.

Software configuration

All vApus testing was done one ESXi vSphere 5--VMware ESXi 5.0.0 (b 469512 - VMkernel SMP build-348481 Jan-12-2011 x86_64) to be more specific. All vmdks use thick provisioning, independent, and persistent. The power policy is "Balanced Power" unless indicated otherwise. All other testing was done on Windows 2008 R2 SP1.

Other notes

Both servers were fed by a standard European 230V (16 Amps max.) powerline. The room temperature was monitored and kept at 23°C by our Airwell CRACs.

We used the Racktivity ES1008 Energy Switch PDU to measure power. Using a PDU for accurate power measurements might same pretty insane, but this is not your average PDU. Measurement circuits of most PDUs assume that the incoming AC is a perfect sine wave, but it never is. However, the Rackitivity PDU measures true RMS current and voltage at a very high sample rate: up to 20,000 measurements per second for the complete PDU.

Originally published at https://www.anandtech.com/show/5058/amds-opteron-interlagos-6200 (Wayback Machine).