Enermax Gold: Modu87+ and Pro87+
- Posted in
- Cases/Cooling/PSUs
Temperatures, Fan Speed, and Acoustic Noise



We have tested these units in a chamber with a constant temperature of 50°C to see if they are up to the challenge and don't blow up on us. Well, what can we say? The graphs above show the output temperature measured 1cm in front of the rear vent on each power supply. The measured temperature is just a few degrees over the input temperature. This means that the components inside produce very little heat that actually needs to be dissipated. This is related to the high efficiency these units are able to achieve, as we will see on the next page.

When you switch on these units and the fan starts turning you can actually almost see each blade while it turns. Enermax came up with a very good fan motor design and IC. The company is therefore able to lower the fan speeds to incredible 330 RPM, which is normally only possible with a PWM fan control. Enermax cannot use that approach (without paying royalties) since Antec has a patent on PWM fan controllers inside power supplies.

The low fan RPM continues through most loads, and even when we loaded the power supplies to their limits and left them running for longer periods of time we were not able to clearly hear the fans. When you put your ear close to a unit you will be able to hear a very light hum under full load but that's about it. Under lower loads you will never hear the fan and this makes these units unbeatable compared to the current competition of fan-cooled power supplies. Since all three units have the same curve we only included the 500W unit on the above graphic.
Originally published at https://www.anandtech.com/show/2920 (Wayback Machine).