Archive 1997–2024

Thermaltake Spedo Advanced Chassis

Specifications

Thermaltake Spedo Specifications
Motherboard Form Factor ATX, Micro ATX
Drive Bays External 7x 5.25", 1x 3.5"
Internal 6x 3.5"
Cooling Front 1x 140mm intake
Rear 2x 120mm exhaust
Top 1x 230mm exhaust
Side 1x 230mm intake
Bottom 1x 120mm (Optional)
Expansion Slots 8
Front I/O Port 2x USB, 1x Audio, 1x Micro , 1x eSATA
Power Supply Size Standard ATX
Weight 8.66kg
Dimensions 610 x 232 x 536 (WxHxD in mm)

The initial impression on opening the case is that the interior is very roomy. There are several covers at the bottom; the first one covers the power supply and the second one above is the A.T.C.3. You can see a small green PCB at the bottom, which is another unique feature Thermaltake offers with the Spedo. This contact board has a counterpart on the side panel. When you close the panel, the two board connect to each other and enable the fan in the panel to run -- there's no need for additional cables or connections. If you install the PSU facing down with a 120mm fan, there is a filter to keep out the dust. Unfortunately the opening just beside this does not come with a filter. The other side reveals the C.R.M.3 that contains four table-like plastic parts connected to the back behind the motherboard. All cables going through the case can be stored under these parts.

System Installation

The installation of parts is easy and the first impression of a big interior space is confirmed, as there's ample room after installing a normal size ATX motherboard. Space beside and above the motherboard allows you to easily route cables and helps allow air to circulate and cool the various components. Even longer video cards will fit inside of this case with no conflicts on the right side. The hard drives install without tools since Thermaltake provides a handy tightening system in the hard drive frames.

Our only minor complaint is that after installing our standard test bed, we installed all of the plastic covers again and found that the cover above the power supply touches the third graphics cards in our triple-SLI setup. This prevents fresh air from reaching the card's intake fan, which will almost certainly cause problems. As you will see on the next page, the definitely impacts GPU cooling.

Originally published at https://www.anandtech.com/show/2700 (Wayback Machine).