Archive 1997–2024

Power Supply Roundup: Eight 1000W for the Extreme Users

Kingwin Mach 1 1000W (ABT-1000MA1S)



Kingwin sent us their Mach 1, a somewhat rare product these days since it still has numerous lights adding bling-bling. This is a fad from a few years back that most users no longer care for, but as with all fads there are some holdouts. It's interesting to see Kingwin's take on the lighted PSU market. The jacks on the front for the cable management have an acrylic ring around them. If you connect a harness and power on the unit, the ring will illuminate. This is mostly a useless function since it's difficult to see this when the power supply is installed in a case (even with a window), and it should also be readily apparent which sockets have cables attached. Still, it's different enough to warrant mention. The rest of the PSU looks sleek with a color scheme and fan that fit with the lighting.



This particular model comes with six 12V rails, four rated at 20A and two at 35A. The total combined power of the 12V rails is 960W (in theory), and the total combined power of all rails is just 10W more. So it should be possible to load the 12V rails very high, but only with minimal loading on the lower rails. In truth, six 12V outputs from only one transformer is a strange approach.



The cable harnesses are all sleeved with mesh as usual. The jacks in the back of the power supply have different pins sticking out which only allows the correct harness to be connected to the right jack. The Mach 1 has two 6-pin and two 6/8-pin PEG connectors for a decent SLI/CF setup. The 50cm cable length is okay but nothing special. Eight SATA and eight Molex connectors are also sufficient, but other units provide more options.



The heatsinks are flat and very thin. The incoming air through the bottom blows fresh air directly on the fins, which have enough space to let air reach the components underneath the fins. The flat structure may block some air or create unwanted turbulences, but we will wait for the temperature and noise testing to verify this. The primary cap is located in the middle of the PCB and made by CapXon. It's rated at 560µF and 400V at just 85°C.

Originally published at https://www.anandtech.com/show/2395 (Wayback Machine).