DFI UT P35-T2R: Tweakers Rejoice!
- Posted in
- Motherboards
Benchmark Performance Comparisons
Next, we wanted to look at the performance of various FSB/divider combinations with 2GB/4GB of RAM. We decided to stick with our tuned 465FSB 1333/800 strap overclock, comparing results between lower FSBs on the 266 strap whilst retaining around 3.72GHz of CPU speed. Any assessments within this section are scrutinized upon the principle of lowest voltages for stable operation at the most effective performance point.
With 4GB of memory in place and the 266 strap we used a Performance Level of 6 when clocking over 400FSB. We used the 266/667 combo@ 414FSBx9 to mimic the CPU speed of 465x8 using the 333/800 divider. Although there is an obvious memory speed disadvantage using the 266/667 combination, justification for doing so was the low VDimm we used for the 465FSB overclock: only 2.12 VDimm was required. While 5-4-4 timings @ 1034MHz using the 266/667 combination demanded around 2.2 VDimm, both are reasonable enough for long-term everyday use.
Using the 266/800 divider would have set the memory speed well in excess of 1200MHz, which quite frankly would require outside warranty specification voltages to operate, including higher VNB to even benchmark the board.
All 3D benches/comparisons were run with an NVIDIA 8800 Ultra clocked at 692/1205
4GB RAM And 333/800 Strap Benchmarks
3DMark01
3DMark06
Company of Heroes 1920x1200

Company of Heroes 1280x1024

Cinebench R10
SuperPi 32M
Next, we wanted to look at the performance of various FSB/divider combinations with 2GB/4GB of RAM. We decided to stick with our tuned 465FSB 1333/800 strap overclock, comparing results between lower FSBs on the 266 strap whilst retaining around 3.72GHz of CPU speed. Any assessments within this section are scrutinized upon the principle of lowest voltages for stable operation at the most effective performance point.
With 4GB of memory in place and the 266 strap we used a Performance Level of 6 when clocking over 400FSB. We used the 266/667 combo@ 414FSBx9 to mimic the CPU speed of 465x8 using the 333/800 divider. Although there is an obvious memory speed disadvantage using the 266/667 combination, justification for doing so was the low VDimm we used for the 465FSB overclock: only 2.12 VDimm was required. While 5-4-4 timings @ 1034MHz using the 266/667 combination demanded around 2.2 VDimm, both are reasonable enough for long-term everyday use.
Using the 266/800 divider would have set the memory speed well in excess of 1200MHz, which quite frankly would require outside warranty specification voltages to operate, including higher VNB to even benchmark the board.
All 3D benches/comparisons were run with an NVIDIA 8800 Ultra clocked at 692/1205
4GB RAM And 333/800 Strap Benchmarks
3DMark01
![]() |
3DMark06
![]() |
Company of Heroes 1920x1200

Company of Heroes 1280x1024

Cinebench R10
![]() |
SuperPi 32M
![]() |
Originally published at https://www.anandtech.com/show/2354 (Wayback Machine).



