µATX Part 2: Intel G33 Performance Review
- Posted in
- Motherboards
ASUS P5K-VM: Overclocking
Our best results with the integrated graphics solutions was a final benchmark stable setting of 9x333 FSB resulting in a clock speed of 2999MHz. However, this required a CPU voltage setting of 1.425V, and memory remaining at DDR2-800.
Our best results with the E2160 and with an external graphics card was a final benchmark stable setting of 9x320 FSB resulting in a clock speed of 2881MHz with a CPU voltage setting of 1.35V. We were able to run our memory at DDR2-961 with timings of 5-5-5-18 at 2.1V. This pattern was continued with the other G33 boards. Due to strap and chipset timing changes within the BIOS, we could not run our E2160 higher than a 333FSB without locking up the board. We did modify another E2160 to run natively at 1066FSB and did reach a final 9x385 FSB setting.
We were able to run the E6550 up to 7x485 FSB on 1.425V and memory at DDR2-970 with 2.10V. Memory timings were set to 5-5-5-15. Vdrop/Vdroop was very good on this board with an average of .02V ~.03V difference during load conditions.
Our Q6600 was able to make it to 9x400 with voltage settings around 1.40V to 1.425V. The board would actually reach around 435FSB with this particular CPU but we were already at the limits of our cooling solution at the 9x400 setting. Memory had to remain at a 1:1 ratio resulting in DDR2-800 settings with 4-4-4-12 timings.
![]() |
| Click to enlarge |
Our best results with the integrated graphics solutions was a final benchmark stable setting of 9x333 FSB resulting in a clock speed of 2999MHz. However, this required a CPU voltage setting of 1.425V, and memory remaining at DDR2-800.
![]() |
| Click to enlarge |
Our best results with the E2160 and with an external graphics card was a final benchmark stable setting of 9x320 FSB resulting in a clock speed of 2881MHz with a CPU voltage setting of 1.35V. We were able to run our memory at DDR2-961 with timings of 5-5-5-18 at 2.1V. This pattern was continued with the other G33 boards. Due to strap and chipset timing changes within the BIOS, we could not run our E2160 higher than a 333FSB without locking up the board. We did modify another E2160 to run natively at 1066FSB and did reach a final 9x385 FSB setting.
![]() |
| Click to enlarge |
We were able to run the E6550 up to 7x485 FSB on 1.425V and memory at DDR2-970 with 2.10V. Memory timings were set to 5-5-5-15. Vdrop/Vdroop was very good on this board with an average of .02V ~.03V difference during load conditions.
![]() |
| Click to enlarge |
Our Q6600 was able to make it to 9x400 with voltage settings around 1.40V to 1.425V. The board would actually reach around 435FSB with this particular CPU but we were already at the limits of our cooling solution at the 9x400 setting. Memory had to remain at a 1:1 ratio resulting in DDR2-800 settings with 4-4-4-12 timings.
Originally published at https://www.anandtech.com/show/2339 (Wayback Machine).



