Archive 1997–2024

Seagate 7200.10 500GB: Hitting the Sweet Spot

Feature Set: Seagate Barracuda 7200.10 500GB


The external casing design of the Seagate Barracuda 7200.10 series is basically unchanged from the previous generation 7200.9 series. The drive is based on the industry standard 3.5" form factor platform with pertinent part number and warranty information embossed on a white sticker on the top of the casing. However boring the exterior design may be, lurking under the plain casing is 500GB of storage capacity. Based upon the potential of perpendicular technology this same casing could be holding two terabytes of capacity within the next couple of years.


The 7200.10 SATA family ships with the Serial ATA data and power connectors only. There is no longer support for 4-pin Molex power connectors designed for use with older ATX power supplies. To the left of the data and power connectors is a 4-pin jumper block. This jumper block will determine whether the drive operates in Serial ATA/150 or Serial ATA-II/300 mode. Two pins are enabled by default, meaning the Seagate Barracuda 7200.10 ships and will operate in SATA/150 mode.

In order for the drive to operate in Serial ATA-II/300 mode, the jumper must be removed. Enabling SATA-II/300 is recommended if you have a compatible motherboard that fully supports SATA-II/300 operations. While this feature was advantageous for burst transfer rates in our synthetic benchmarks, overall we did not see any noticeable improvement in our real world benchmarks.


The PCB is openly visible on the bottom of the drive as in previous series and contains a ST Micro controller chip. The ST Micro Serial ATA controller chipset is standard for Seagate now after using the Agere chipset for some time.

Originally published at https://www.anandtech.com/show/2268 (Wayback Machine).