ASRock 939Dual-SATA2: First Retail ULi PCIe/AGP
- Posted in
- Motherboards
Memory Stress Testing
Our memory stress test measures the ability of the ASRock 939Dual to operate at its officially supported memory frequency (400MHz DDR), at the lowest memory timings that OCZ PC3200 Platinum Rev. 2 modules will support. All DIMMs used for stress testing were 512MB double-sided (or double-bank) memory. To make sure that memory performed properly in Dual-Channel mode, memory was only tested using either one dual-channel (2 DIMMs) or 2 dual-channels (4 DIMMs).We had established in our initial reviews of the ULi chipset that the best memory performance was achieved at a tRAS setting of 10T with this chipset. Therefore, all testing used the best performing 2-2-2-10 settings.
| Stable DDR400 Timings - One Dual-Channel (2/4 DIMMs populated) |
|
| Clock Speed: | 200MHz |
| CAS Latency: | 2 |
| RAS to CAS Delay: | 2T |
| RAS Precharge: | 10T |
| Precharge Delay: | 2T |
| Command Rate: | 1T |
Using two DIMMs in Dual-Channel 128-bit mode, the memory performed in all benchmarks at the fastest 2-2-2-10 timings at default voltage.
| Stable DDR400 Timings – 4 DIMMs (4/4 DIMMs populated) |
|
| Clock Speed: | 200MHz |
| CAS Latency: | 2.0 |
| RAS to CAS Delay: | 2T |
| RAS Precharge: | 10T |
| Precharge Delay: | 2T |
| Command Rate: | 2T |
Tests with all four DIMM slots populated on the ASRock 939Dual-SATA2 required a 2T Command Rate with 4 DIMMs in two dual channels. This is the pattern seen on every other top-performing Socket 939 board. This performance is completely competitive with the best that we have seen on nForce4 motherboards for Socket 939. It needs to be pointed out, however, that cold boot problems increased significantly when running 4 DIMMs. The cold boot issue may be as simple as a revised BIOS to support Samsung TCCD better on this board. Whatever the solution, solving the cold boot issue is a must for ASRock.
Originally published at https://www.anandtech.com/show/1782 (Wayback Machine).