Archive 1997–2024

AMD Motherboards: Processor Support

Updating DC BIOS & Revision E Memory

Updating BIOS for Dual Core with an x2 Processor

This brings up the nagging question that is always asked when BIOS upgrades are required for certain CPUs. What do you do if you have a board that needs a BIOS upgrade for dual-core and you only have a dual-core chip? We asked AMD this question and got the following reply:

"If the BIOS you are working with (original BIOS in the board) supports a rev E single core (AKA... 90nm as most new boards should), it will allow you to flash the BIOS to a BIOS that supports rev E dual core. In my experience, a DC processor with single core rev E support will run fine, but only as a single core. If the BIOS doesn't support rev E (In other words, you may have a good board, but the BIOS is pretty old), you will likely need to install a pre-rev E (AKA-130nm) AMD processor to flash the BIOS.

I'm told that if a customer can't flash their BIOS, many mobo vendors will mail out the BIOS chip to them (if it's not soldered down, obviously)"


Revision E Memory Controller PLUS 4 Dimms =

The memory timings, in the end, are controlled by the memory controller, and in the case of Athlon 64 that memory controller is on the processor. We had already been told by AMD that Rev. E would feature a new and improved memory controller. In fact for months prior to the release of the new Revision E Athlon 64 processors (Venice, San Diego, Toledo) we have been hearing that the new memory controller on the Rev. E chips would allow the use of 4 dimms at the faster 1T Command Rate.

With the 4200+ x2 in our DFI LANParty nForce4 SLI test bed with a working dual-core BIOS (6/23/05) we tried 4 matched PC3200 OCZ Platinum Rev. 2 dimms. Four double-sided (or double- bank) dimms STILL require a 2T command rate in this configuration, so the limitation stills remains. Four DS Dimms in a Rev. E still need a Command Rate of 2.

Originally published at https://www.anandtech.com/show/1723 (Wayback Machine).