Archive 1997–2024

nForce4 SLI Roundup: Painful and Rewarding


MSI K8N Neo4/SLI Platinum: Overclocking and Stress Testing

FSB Overclocking Results

Front Side Bus Overclocking Testbed
MSI K8N-Neo4/SLI
Processor: Athlon 64 4000+
(2.4GHz, 1MB Cache)
CPU Voltage: 1.55V (default 1.50V)
Cooling: Thermaltake Silent Boost K8 Heat sink/Fan
Power Supply: OCZ Power Stream 520W
Memory: OCZ PC3200 EL Platinum Rev. 2
(Samsung TCCD Memory Chips)
Hard Drive: Seagate 120GB 7200RPM SATA 8MB Cache
Maximum OC:
(Standard Ratio)
235x12 (Auto HT, 2-3-2-7, 1T, 2.85V)
2820MHz (+18%)
Maximum FSB:
(Lower Ratio)
312x9 (2808MHz) (Auto HT, 2.5-4-3-7, 2.85V)
(1:1 Memory, 1T, 2 DIMMs in DC mode)
(+56% Bus Overclock)

MSI has a much more limited range of overclocking controls than the top-performing DFI, but that doesn't seem to limit much the overclocking abilities of the SLI. The K8N Neo4/SLI continued the MSI tradition of top Athlon 64 overclocking by reaching a CPU speed of 312 (DDR624), just slightly short of the DFI record of 318. We would likely have been able to push the MSI even higher were it not for the limitation of a 2.85 top memory voltage, compared to 4.0V on the DFI.

At stock multipliers, MSI was also an excellent overclocker, reaching 235. This is just shy of the 238 reached by the DFI. All-in-all, the MSI was a great performer and extremely so in our testing. The MSI K8N Neo4/SLI was much easier to overclock than the K8N Neo2, which is a recent Editor's Choice among Socket 939 motherboards.

Memory Stress Test Results:

Our memory stress test measures the ability of the MSI to operate at its officially supported memory frequency (400MHz DDR), at the lowest memory timings that OCZ PC3200 Platinum Rev. 2 modules will support. All DIMMs used for stress testing were 512MB double-sided (or double-bank) memory. To make sure that memory performed properly in Dual-Channel mode, memory was only tested using either one dual-channel (2 DIMMs) or 2 dual-channels (4 DIMMs).

Stable DDR400 Timings - One Dual-Channel
(2/4 DIMMs populated)
Clock Speed: 200MHz
CAS Latency: 2.0
RAS to CAS Delay: 2T
RAS Precharge: 7T
Precharge Delay: 2T
Command Rate: 1T

Using two DIMMs in Dual-Channel 128-bit mode, the memory performed in all benchmarks at the fastest 2-2-2-7 timings, at default 2.6V voltage.

Tests with 4 DS DIMMs on an AMD Athlon 64 system are more demanding, since AMD specifies DDR333 for this combination. However, most AMD Athlon 64 motherboards combined with recent AMD processors (the memory controller is on the AMD CPU) have been able to handle 4 DIMMs at DDR400.

Stable DDR400 Timings - 4 DIMMs
(4/4 DIMMs populated)
Clock Speed: 200MHz
CAS Latency: 2.0
RAS to CAS Delay: 2T
RAS Precharge: 7T
Precharge Delay: 2T
Command Rate: 2T

Tests with all four DIMM slots populated on the MSI K8N Neo4/SLI board required a 2T Command Rate with 4 DS DIMMs in two dual channels. This is the pattern seen on other top-performing Socket 939 boards, and is a limitation of the AMD on-chip memory controller. Additional voltage did not help and DDR400 with 4DS DIMMs still required a 2T Command Rate as we have seen on other nF4 boards. We are hopeful that the upcoming Rev. E Athlon 64 chips will at least allow a 1T Command Rate with 4 DS DIMMs.

Originally published at https://www.anandtech.com/show/1626 (Wayback Machine).