FIRST LOOK: SiS 755FX for Socket 939 Athlon 64
- Posted in
- Motherboards
Memory Stress Testing
Our memory stress test measures the ability of the Winfast to operate at its officially supported memory frequency (400MHz DDR), at the lowest memory timings that OCZ PC3200 Platinum Rev. 2 modules will support. All DIMMs used for stress testing were 512MB double-sided (or double-bank) memory. To make sure memory performed properly in Dual-Channel mode, memory was only tested using either one dual-channel (2 DIMMs) or 2 dual-channels (4 DIMMs).| Stable DDR400 Timings - One Dual-Channel (2/4 DIMMs populated) |
|
| Clock Speed: | 200MHz |
| CAS Latency: | 2 |
| RAS to CAS Delay: | 2T |
| RAS Precharge: | 10* |
| Precharge Delay: | 2T |
| Command Rate: | 1T |
Using two DIMMs in Dual-Channel 128-bit mode, the memory performed in all benchmarks at the fastest 2-2-2-10 timings at default voltage, which was the only memory voltage available.
| Stable DDR400 Timings - 4 DIMMs (4/4 DIMMs populated) |
|
| Clock Speed: | 166MHz |
| CAS Latency: | 2.0 |
| RAS to CAS Delay: | 2T |
| RAS Precharge: | 10* |
| Precharge Delay: | 2T |
| Command Rate: | 2T |
Tests with all four DIMM slots populated on the 755FX required a 2T Command Rate with 4 DIMMs in two dual channels. This is the pattern seen on other top-performing Socket 939 boards. However, without a 200 (DDR400) setting in BIOS, 4 DS DIMMs booted at DDR333. This is a common occurrence on other Athlon 64 motherboards, but most other boards allow a selection of DDR400 in BIOS to force DDR400 with 4 DS DIMMs. Foxconn needs to add a 200 setting to their Memory Speed settings. This may or may not allow 4 DS DIMMs to run at DDR400 speed, but it would allow us to determine whether the board could support 4 DS DIMMs at DDR400. For now, consider this board limited to DDR333 with 4 DS DIMMs.
Originally published at https://www.anandtech.com/show/1569 (Wayback Machine).