Intel's Long Awaited BTX Form Factor
- Posted in
- Cases/Cooling/PSUs
Examining BTX cont'd
The D915GMH is essentially a microBTX version of our D915GUX motherboard with a few functional differences on top of the obvious BTX design. When we first laid eyes on the D915GMH the first thing we noticed was the arrangement of the CPU socket, Northbridge, and Southbridge. The CPU socket is placed at the front of the motherboard with the Northbridge behind it slightly to the left and the Southbridge behind the Northbridge directly in line with the CPU socket. Each is positioned on a diagonal which we assume will improve air flow around all three chips. Since these components are three of the hottest running components in a PC it made sense to position them in line from front to back and we expect fans to be placed in that same linear arrangement.A design that revolves so much around irregularly placed components was slightly unusual for us to see. Although software dictates the exact routing of all the traces from component to component, its very obvious that some very complicated math went into assuring each bridge and component was placed correctly. The fact that almost nothing seems to be at a right angle is a little overwhelming at first.
The IDE and Floppy ribbon headers were separated on the board. We found this to be inefficient, especially for the floppy drive, since they are on opposite sides of the system. Though not as important nowadays since SATA drives are moving into mainstream PCs, those who would like to use floppy drives are left with only the option of using a lengthy rounded cable. Since the AOpen/Intel combination we received today looks more like an OEM design than something we would typically buy and assemble from NewEgg, problems with the floppy cable placement shouldn't be a huge issue.

Click to Enlarge
There are 4 DDR memory sockets which are placed at the far left edge of the board. Keep in mind our D915GMH runs on DDR2, but other than design layout that is the only major difference between our microATX and microBTX motherboards.

Click to Enlarge
The PCIe x16 slot is positioned about 3 inches from the rightmost edge of the D915GMH. Since the AOpen B300 is a half height case a riser card is included for the PCIe x16 slot. This allows the VGA card to be mounted towards the center of the motherboard to keep it inline with the CPU and chipset.
Originally published at https://www.anandtech.com/show/1544 (Wayback Machine).