Archive 1997–2024

SilverStone Technology Temjin 6: Another BTX Style in an ATX Form


Installation

Installation of all of the components was a bit easier in this case than in many other cases. There weren't that many wires hanging around waiting to be plugged in or just getting in the way, which made it easier to install components such as the motherboard.

The power supply was also easier to install, since it came in directly through the back. Unlike the Tsunami Dream that we looked at a few weeks ago, where we had to remove the auxiliary ports to get the power supply in, the back plate on the Temjin 6 was removable to insert the power supply.




Click to enlarge.


From that point on, everything else was a breeze to install. The total time for installation was about 7-9 minutes. We did notice one thing, however, with the HDD bay - the amount of clearance on the left side between the left side panel and the installed HDDs. There was barely enough room for wiring, especially if a 4-pin molex power connector is required for an IDE hard drive. We used a Seagate SATA drive, which wasn't too much of a problem, but nevertheless, we do recommend using L-type data cables to reduce bending of the cables.




Click to enlarge.


Originally published at https://www.anandtech.com/show/1487 (Wayback Machine).