Archive 1997–2024

Socket 754 Roundup, Part 3: Asus, Soltek & DFI


Soltek K8AN2E-GR: Overclocking and Stress Testing

FSB Overclocking Results


Front Side Bus Overclocking Testbed
Default Voltage
Processor: Athlon 64 3200+
2.0GHz
CPU Voltage: 1.5V (default)
Cooling: Thermaltake Silent Boost K8 Heatsink/Fan
Power Supply: OCZ Power Stream 520W
Memory: OCZ PC3200 EL Platinum Rev. 2
or Geil PC3200 Ultra X
Maximum OC:
(Standard Ratio)
246 x 10 (IDE), 230 x 10 (SATA)
2460MHz (+23%)
Maximum FSB:
(Lower Ratio)
250 x 9 (1:1 Memory, IDE, 2 DIMMs)
230 x 9 at (1:1 Memory, SATA, 2 DIMMs)

While the Soltek SL-K8AN2E-GR fared a bit better than the Asus with SATA drives, both sets of SATA connections still limited the maximum overclock. The board managed to reach a more respectable 250 CPU setting (the maximum available with the latest BIOS) with an IDE drive, but this is still far short of the 270 to 316 that we have seen with other nForce3-250 boards.

We suspect that the Soltek can do much better than 250 with lower ratios, but that is the current limit of the CPU range. If Soltek fixes this oversight with a BIOS update, you will likely be able to achieve higher performance with the K8AN2E-GR. The other controls that are needed for excellent overclocking with the Soltek are all here.

Memory Stress Test Results:

The memory stress test measures the ability of the Soltek K8AN2E-GR to operate at its officially supported memory frequency (400MHz DDR), at the best performing memory timings that our OCZ PC3200 Rev. 2 modules will support. Memory stress testing was conducted by running RAM at 400MHz with 2 DIMM slots filled. However, please keep in mind that Socket 754 is single-channel and will still operate at top speed with just one DIMM.

Stable DDR400 Timings - 2 DIMMs
(2/2 DIMMs populated)
Clock Speed: 200MHz
Timing Mode: N/A
CAS Latency: 2.0
RAS to CAS Delay: 2T
RAS Precharge: 10T*
Precharge Delay: 2T
Command Rate: 1T
*Several memory tests have shown that memory performs fastest on the nVidia nForce chipsets at a TRas (RAS Precharge) settings in the 9 to 13 range. We ran our own Memory Bandwidth tests with memtest86 with TRas settings from 5 to 15 at a wide range of different memory speeds. The best bandwidth was consistently at 9 to 11 at every speed, with TRas 10 always in the best range at every speed. The performance improvement at TRas 10 was only 2% to 4% over TRas 5 and 6 depending on the speed, but the performance advantage was consistent across all tests. All benchmarks were run at a TRas setting of 10.

The Soltek K8AN2E-GR was completely stable with 2 DIMMs at the best performing settings of 2-2-2-10, at default speed. The Soltek has just 2 DIMM slots and does not support 3 DIMMs.

Originally published at https://www.anandtech.com/show/1474 (Wayback Machine).