DFI LANParty UT nF3-250Gb: Overclocker's Dream
- Posted in
- Motherboards
Memory Stress Testing: DFI LANParty UT nF3 250Gb
The memory stress test is very basic, as it simply tests the ability of the DFI nF3 250Gb to operate at its officially supported memory frequency (400MHz DDR), at the lowest memory timings that OCZ PC3200 Platinum Rev. 2 Modules will support. Because of the numerous questions that have been asked about the number of DIMMs on Socket 754 boards, Memory Stress Testing was conducted by running 1 DIMM, 2 DIMMs, and all 3 DIMMs at DDR400. All DIMMs used for stress testing were 512MB double-sided (or double-bank) memory.| Stable DDR400 Timings - 1 DIMMs (1/3 DIMMs populated - Single-Channel mode) |
|
| Clock Speed: | 200MHz |
| CAS Latency: | 1.5 |
| RAS to CAS Delay: | 2T |
| RAS Precharge: | 10T* |
| Precharge Delay: | 2T |
| Command Rate: | 1T |
We have not tested a Socket 754 board that offered a CAS 1.5 setting. The OCZ memory ran without problems with 1 DIMM at 1.5-2-2-10 settings.
| Stable DDR400 Timings - 2 DIMMs (2/3 DIMMs populated - Single-Channel mode) |
|
| Clock Speed: | 200MHz |
| CAS Latency: | 2.0 |
| RAS to CAS Delay: | 2T |
| RAS Precharge: | 10T* |
| Precharge Delay: | 2T |
| Command Rate: | 1T |
All earlier 754 benchmarks were run with 2 DIMMs, and this is the configuration that was used for all standard benchmark tests. The DFI LANParty UT was completely stable with 2 DIMMs at the rated timings of 2-2-2-10 at default speed.
Filling all three available memory slots is more strenuous on the memory subsystem than testing 2 DIMMs on a motherboard. We were very pleased to find that 3 DS DIMMs (1.5GB) of memory worked fine at timings almost the same as the aggressive timings that we used for 2 DIMMs. The DFI is one of the few Socket 754 boards that we have tested which can handle 3 DS DIMMs. You do need to use slightly slower timings with 3 DIMMs, but the 2-2-3-10 is very close to the rated 2-2-2-10 timings of the memory which we used for testing.
| Stable DDR400 Timings - 3 DIMMs (3/3 DIMMs populated - Single-Channel mode) |
|
| Clock Speed: | 200MHz |
| CAS Latency: | 2.0 |
| RAS to CAS Delay: | 3T |
| RAS Precharge: | 10T* |
| Precharge Delay: | 2T |
| Command Rate: | 2T |
The boot screen and Sisoft Sandra 2004 both reported a Command Rate of 2T when all 3 DIMM slots were filled.
Originally published at https://www.anandtech.com/show/1466 (Wayback Machine).