Computex 2004: BTX at the Show
- Posted in
- Trade Shows
Remember the 4-pin fan header from before? Here's another pic:

What makes the 4-pin fan headers so interesting? They allow for linear fan speed control. Currently fans can only be adjusted in steps, e.g. running at 800RPM, 1500RPM or 3000RPM. The problem with this situation is that there's an abrupt increase in fan speed and thus fan noise. What these new 4-pin fan headers will allow is a linear increase in fan speed, so the fan speed and noise increases are much more gradual. Unfortunately the fan controllers that will enable this linear functionality are not yet ready and they won't be for another quarter or so.
Taking a page from the BTX spec, Shuttle's 925X system has a thermal module that is used to cool the CPU. We've taken the cover off of the front of the module for better visibility:

Here's where Shuttle's solution differs from BTX; the BTX spec calls for cool air to be brought in from the front of the case to cool the CPU, then flow over the chipset and finally by the GPU before exiting the system. Shuttle rotated the thermal module so that it pulls in cool air from the sides and exhausts it out the opposite side. The downside is that the chipset doesn't get any cool air running over it, but the benefit is that it will reduce the ambient temperature of the case.
Although you still open the chassis using thumbscrews, Shuttle has moved to a screw-less design for the hard drives:
The top of the chassis is big enough to hold two drives, and is wired for SATA power/data cables already; the idea is to use the top bays for RAID, cooled by the two fans we saw earlier. The two plastic rails you see in the picture above snap into either side of a hard drive, then snap into place on the chassis itself. The installation process is quite simple.
Originally published at https://www.anandtech.com/show/1340 (Wayback Machine).