Archive 1997–2024

Dell UltraSharp 2001FP Preview: Gaming LCDs for the Masses


Construction (continued)


 Dell 2001FP
LCD 20.1" UXGA LCD (Active Matrix)
pixel pitch: 0.255mm
Anti-glare coating
Super IPS Mode
Scanning Frequency Horizontal: 31-80kHz (analog)
Vertical: 56-76Hz
Response Time 16ms (Typical)
Contrast Ratio 400:1 (Typical)
Compatibility 1600 x 1200 (Native)
Brightness 250 cd/m2
Dimensions (WxHxD) 16.4"x 17.7" x 8.2"
Power Working: 90W Max
Standby/Off: 5W
Weight 15.4lbs
Warranty 3 years parts and labor

Notice a few quick things from these specifications. First of all, the contrast ratio of 400:1 is quite modest in comparison to other LCDs on the market. As we will find out later on in the benchmarking of this monitor, it is perhaps the most honest too. The 16ms response time and Super IPS display modes are dead giveaways that this is an LG.Philips LCD panel.



Ventilation is provided by about 20 1/8" holes under the inputs on the screen, as well as small slits all around the backside of the panel. We have been hesitant to commend screens that have excessive ventilation because it poses concern for dust buildup inside the unit. The Samsung 192T did an excellent job of dissipating heat without any ventilation holes.


Click to enlarge.


Our monitor came with 5 dead subpixels. Two blue, two greens and a red/green pair were stuck off. The greens were all within a 2" diameter of each other, and the blues were near the center of the screen, which is a noticeable shame. All of the broken pixels were in the lower left quadrant of the screen. However, considering the density and volume of pixels (1600x1200), we expected a higher pixel failure rate. Dell has informed us that had this been an actual production unit, and not a pre-production sample, the defect rate would have been much lower.

Originally published at https://www.anandtech.com/show/1193 (Wayback Machine).