Archive 1997–2024

The Crucial BX300 (480GB) SSD Review: Back To MLC

Power Management

Real-world client storage workloads leave SSDs idle most of the time, so the active power measurements presented earlier in this review only account for a small part of what determines a drive's suitability for battery-powered use. Especially under light use, the power efficiency of a SSD is determined mostly be how well it can save power when idle.

SATA SSDs are tested with SATA link power management disabled to measure their active idle power draw, and with it enabled for the deeper idle power consumption score and the idle wake-up latency test. Our testbed, like any ordinary desktop system, cannot trigger the deepest DevSleep idle state.

Idle power management for NVMe SSDs is far more complicated than for SATA SSDs. NVMe SSDs can support several different idle power states, and through the Autonomous Power State Transition (APST) feature the operating system can set a drive's policy for when to drop down to a lower power state. There is typically a tradeoff in that lower-power states take longer to enter and wake up from, so the choice about what power states to use may differ for desktop and notebooks.

We report two idle power measurements. Active idle is representative of a typical desktop, where none of the advanced PCIe link or NVMe power saving features are enabled and the drive is immediately ready to process new commands. The idle power consumption metric is measured with PCIe Active State Power Management L1.2 state enabled and NVMe APST enabled.

Active Idle Power Consumption (No LPM)Idle Power Consumption

The active idle power consumption of the Crucial BX300 is the same as for the BX200. Both are a bit on the high side, but there are Silicon Motion drives with both higher and lower active idle draws. With SATA link power management enabled, the BX300's idle power draw is better than average, but 20mW worse than what the BX200 and Intel 545s manage with older and newer Silicon Motion controllers.

Idle Wake-Up Latency

The BX200 had a serious problem with idle wake-up latency of over 10ms, which the BX300 has fixed. The BX300 wakes up quickly, though the drives with the Phison S10 controller are still the quickest by far.

Originally published at https://www.anandtech.com/show/11766/the-crucial-bx300-480gb-ssd-review-back-to-mlc (Wayback Machine).